3Com AirConnect 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} 3Com AirConnect에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com AirConnect 15 페이지. 2.0 wireless lan
3Com AirConnect에 대해서도 마찬가지입니다: 먼저 읽기 (2 페이지)

페이지 인쇄

4 Carefully insert the PCI card into the selected slot until it seats snugly

(see Figure 1). The shielded part of the wireless PCI card protrudes from

the card faceplate and juts out beyond the back panel of your computer

when the card is installed.

CAUTION: DO NOT REMOVE the shielded part of the PCI card from the

printed circuit carrier.

5 Secure the card with the screw that you removed earlier.

6 Replace the cover of your PC and plug in the power cord.

7 Turn on the power to your computer.

8 Insert the End User Utilities CD in the CD-ROM drive.

The setup program should start automatically. If it does not start, you

can run it manually by selecting Run from the Windows Start menu and

running SETUP.EXE from the CD-ROM drive. The driver installation

procedure guides you through the steps standard for your operating

system.

If you are unfamiliar with driver installation procedures, refer to the

AirConnect Wireless PCI Card User Guide for details. You will be asked

to supply CDs or directory path information for the End User Utilities

CD and your operating system software.

As part of the driver installation process, the setup program will install

and open the Network application in the Control Panel.

9 Enter the name of the Wireless LAN Service Area of the wireless network

to which your computer will connect. The name you enter here must

match exactly the name assigned to the access point. Characters,

capitalization, and spacing must be identical.

NOTE: If the access point you wish to connect to is set for encryption, you

must also enable encryption on the wireless client. Click Encryption in the

Wireless LAN Conﬁguration Utility to go to screens where you can enable

and conﬁgure encryption.

You must set the wireless client for the same encryption algorithm and

shared key values as the access point it will associate with. Refer to the

AirConnect Wireless PCI Card User Guide for more details about conﬁguring

encryption.

10 Save the conﬁguration settings and exit by clicking OK.

11 Restart your computer.

12 When the system reboots, restart the setup program and install any

other components required.

13 Make sure that the network protocol parameters (IP address, gateway,

and subnet mask) are set correctly for your computer.

3Com recommends that you install the wireless LAN applications so you

can access the utilities described in the AirConnect Wireless PCI Card

User Guide.

14 Restart your computer for changes to take effect.

– 2 –