CRU Dataport ToughTech Secure Q 사용자 설명서 - 페이지 6
{카테고리_이름} CRU Dataport ToughTech Secure Q에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CRU Dataport ToughTech Secure Q 12 페이지. Hard drive enclosure
CRU Dataport ToughTech Secure Q에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
CRU
2.2.4
(For the "Secure" model only) Insert the encryption key into the slot on the front of the product.
The green encryption LED will light indicating that the drive is now unlocked. If
you do not plug in the key, your computer will not see the drive and the red
encryption LED will remain lit while ToughTech waits for a key.
After the drive mounts to the computer, you may unplug the key. It will not be
needed again until you cycle power on ToughTech.
2.2.5
Your ToughTech is now ready to use! If your hard drive is already
formatted, you can begin using it right away. If the hard drive is brand new or its format is not compatible
with your computer, you'll need to format the drive before you can use it.
3. WriteLock Information
The information in this section applies only to ToughTech models with the WriteLock feature.
The WriteLock feature lets you "lock down" your data with write-protection. Write-protection is enabled
and disabled with a few simple steps.
3.1 Enabling write protection
3.1.1
Turn the power off using the power switch.
3.1.2
Press and hold the WriteLock enable button while
switching the power back on. The yellow WriteLock
LED will turn on. (In "Secure" models, the encryption
key must be inserted for the LED to light.)
The unit is now in write-protect mode. While in write-protect mode, the data on the drive cannot be
deleted or altered.
3.2 Disabling write protection
3.2.3
Locate the WriteLock disable button on the inside of the rear
panel (circled in red in the picture at right).
3.2.4
Press and hold the WriteLock disable button while
switching the power back on. The WriteLock LED on the rear panel will
turn off. (In "Secure" models, the key must be inserted for the LED to
light.) The unit is now in read/write mode.
With WriteLock, you can prevent the data on ToughTech from being altered when ToughTech
changes hands. By adding evidence tape over ToughTech's chassis screws, you'll be able to tell if the
unit has been opened. Thus, you'll know if the write-protect mode could have been changed while
ToughTech was in another person's possession.
U s e r M a n u a l f o r T T - Q , T T S - Q ( A9 - 0 0 0 - 0 0 0 1 r e v 1 . 5 )
3.2.1
Switch the power off
3.2.2
Slide the bottom panel out of the housing.
WriteLock
enable button
WriteLock LED
- 6 -