CRU Dataport MoveDock DE110 설치 매뉴얼

{카테고리_이름} CRU Dataport MoveDock DE110에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CRU Dataport MoveDock DE110 2 페이지.

MoveDock Carrier Install Guide

This Install Guide is intended for use with the following part numbers:

6543-3300-0900 MoveDock DE110 USB/eSATA

6603-5701-0900 MoveDock DX115 USB/eSATA

Package Contents

1 - MoveDock Docking Station

1 - Power Supply (100-240 VAC NEMA Series 2500)

1 - USB Cable

1- eSATA Cable (MoveDock DE110 only)

Hard Drive Installation

NOTE: A #1 and #2 Phillips screwdriver will be required during this

procedure.

1. Remove the drive cover from the carrier.

2. Carefully insert the drive into the carrier. Slide the drive towards the

Drive Carrier Board so that the I/O connector on the drive mates with

the connector on the Drive Carrier Board. Hold the drive in place and

turn the drive/carrier assembly over.

3. Fasten the drive into place with the four (4) provided screws. Some

drives may require minor adjustment before securing into the carrier

with the screws.

4. Install the drive cover and secure it with the two (2) provided screws.

Figure 1: Carrier Installation

Operation

1. Carefully slide the carrier into the MoveDock making sure the carrier is

aligned properly with the MoveDock. Failure to do so can damage the

MoveDock connectors.

Rugged, Reliable, Mobile, Secure

Figure 2: MoveDock DX115

2. Use the provided USB or eSATA data cable to connect the MoveDock to your

computer. Connect the provided power cable to the docking station. Failure to

use the provided power cable can damage the MoveDock and your hard drive

which may cause the loss of data (see Figure 3).

Figure 3: Power Connector

3. Use the power switch to turn the MoveDock on. The green power LED

will light up when the MoveDock is powered on.

Figure 4: MoveDock DE110

USB Instructions

Setting up the drive for Windows 2000/XP or Mac OS 9.x/X.

Connect the MoveDock to an available USB port. No new drivers are

required. The hard disk drive will be found and a window will pop-up

stating that new hardware has been detected. If the drive has previ-

ously been formatted, the drive will be accessible through My Computer

on PCs and from the desktop on Macs. If the drive is new and has not

been formatted see the Formatting Hard Drive section for instructions.

1-800-260-9800

Do Not Use