Cruise control AP900Ci 빠른 설치 매뉴얼 - 페이지 4
{카테고리_이름} Cruise control AP900Ci에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cruise control AP900Ci 11 페이지.
페이지 인쇄4
DIAGNOSTIC MODE
Optional!
Press and hold
SET key
(lift CM up)
Diagnostics 1:
CM, brake signal,
clutch signal
Operate every function of CM: lift up,
press down, pull forward, press memory
buttons- the system must respond to
every action with beep signal.
If there no signal check CM and
the wiring of it.
Press brake pedal- the system must
respond with beep signal.
If there no signal check connection of
CAN wires or by analog connection check
brake wires.
Press clutch pedal- the system must
respond with beep signal.
If there no signal use
clutch pedal switch.
Switch the ignition completely OFF to
exit Diagnostics
AP900Ci/ GC90Ci quick installation manual
1X
LOW
Test 1: switch ignition ON
Test 2: start engine
Release SET key
Diagnostics 2:
Accelerator pedal control,
vehicle speed signal
Press and hold SET key- wait until
engine speed increases.
Release SET - engine speed
remains on constant level.
Press and hold RES key- engine speed
decreases.
If not perform pedal learning.
Press and hold SET key- wait until engine
speed increases. Release set and press
brake pedal- engine speed drops idle.
Drive at least 30 km/h - when speed
signal is received will the system give
pulsating beep signals and the led on
the central unit is flashing
If not check CAN wires or learn speed
or use analog speed signal.
Switch the ignition completely OFF to
exit Diagnostics
ProTeam OÜ
Switch speed limiter
ON (push CM back)