Cruise control AP900Ci 빠른 설치 매뉴얼 - 페이지 9
{카테고리_이름} Cruise control AP900Ci에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cruise control AP900Ci 11 페이지.
페이지 인쇄9
ANALOG CONNECTIONS
Engine control
module
High
signal
(voltage) of
accelerator
pedal
Accelerator
pedal
If model specific T-harness is used connect it like
shown on chapter 1.
Above is shown most common connection of
universal pedal harness.
On wire of high signal of accelerator pedal is
usually (but not always) 2 times or 0,7V higher
voltage than on low signal wire.
For example could the voltages on signals wires
be in idle - full throttle position:
High signal: 1,4V - 4,0V
Low signal: 0,7V - 2,0V
or
High signal:1,3V - 4,2V
Low signal: 0,6V - 3,5V
AP900Ci/ GC90Ci quick installation manual
Low
signal
(voltage) of
accelerator
pedal
BROWN
YELLOW
RED
WHITE
Ground of
accelerator
pedal
GREEN
ORANGE
BROWN
BROWN/ WHITE
VIOLET
BLUE
Resistor
YELLOW
NOISE SUPPRESSER
DO NOT REMOVE
Yellow wire is not in use.
If on dedicated installation manual is
recommended to use pul-up resistor to boost
speed signal connect the resistor between
Orange and Blue wire.
Control Module (CM)
Ignition
+12V
Brake pedal
Clutch pedal
Speed pulse
ProTeam OÜ