Cruise N Comfort HD 12s 설치 및 운영 지침 매뉴얼 - 페이지 2

{카테고리_이름} Cruise N Comfort HD 12s에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cruise N Comfort HD 12s 7 페이지. 12 volt air conditioners
Cruise N Comfort HD 12s에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (11 페이지)

페이지 인쇄

3. Run #6 and #8 Refrigerant hoses from Evaporator to condenser

(make sure the green O ring is inside the fitting). Tighten fittings

with open end wrenches. Do not loop lines or have excessive low

points.

4. Run the supplied condenser wire from Evaporator Box to

Condenser Fan. Connect red to red and black to black, solder

together and shrink wrap.

Run the primary 4 gauge or larger power wires from the A/C unit

to the battery no longer than 7 feet. Install a 70 amp marine grade

explosion proof resettable circuit breaker to the positive wire at

battery terminal.

10. Connect A/C Control unit or optional thermostat .

11.

Connect the power and ground connections to the unit fig.8 (make

sure the power switch is in the off position). Do not remove the

compressors power ring terminals that are already installed.

Tighten securely. Make Sure All Electric Connects are Crimped

And Terminal Lugs Are Tight.

14. Connect 4" insulated non conductive vent hose to unit no longer

than 6 feet and run hose to area that is to be cooled. Remember for

best results aim the vent toward the person to be cooled. Mount

vent or ducting assembly and connect hose be sure to use non

conductive hose with a non conductive fastener because of the

close proximity of the main power terminal. Failure to do so could

cause a short or fire. For best results, make sure that air from the

cooled area can be returned with ease to the A/C air inlet on the

front of the unit. The best way of doing this is to mount the unit in

the area that is being cooled . By recycling cool air, unit will

provide coldest air possible. Do not mount this unit in a engine

area or where exhaust and gas fumes can be exposed to this unit.

This unit is NOT explosion proof!! NEVER operate unit without

cover in place and secured!!

Page