Dimplex XMX718N 설치 및 운영 지침 - 페이지 2

{카테고리_이름} Dimplex XMX718N에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex XMX718N 4 페이지. Xms(n) automatic xmx(n) storage heater range

페이지 인쇄

INSTALLATION INSTRUCTIONS

PREPARATION

The heater will arrive

separately from its

storage bricks, the

following bricks will

be required:

LIMIT STAT

CIRCUIT

DIAGRAM

STORAGE ELEMENTS

WARNING

- This appliance must be earthed

Only heat resisting cable (min. rating T85) should be

used. The wires in the mains cable will be coloured as

follows:-

GREEN & YELLOW -

BLUE

BROWN

SUGGESTED FIXINGS

SOLID BRICK/BLOCK: No. 10 Size plastic inserts,

8mm drill bit. Drill hole 15mm deeper than plastic insert

length.

PLASTERBOARD - If possible locate studding and use

No. 10 woodscrews directly into the wood, otherwise

M5 rawlplug intersets are suitable.

NOTE: FOR OTHER WALL TYPES (e.g. Timber frame

and hollow concrete) SEEK SPECIALIST ADVICE.

FIXING ASSEMBLY

ENSURE THAT FIXING KIT AND FEET HAVE BEEN

LOCATED BEFORE DISPOSING OF PACKAGING.

Fit the feet with the open end of the foot to the front of

the heater. Secure each foot using two taptite screws

provided.

Model 706N - 4 bricks

Model 712N - 8 bricks

Model 718N - 12 bricks

Model 724N - 16 bricks

XMS712/718

ROOM

MODELS

CUT OUT

ONLY

STAT

XMS MODELS

ONLY

LIMIT STAT

ROOM

AND

STAT

CUT OUT

EARTH

NEUTRAL

LIVE

Place the heater on its feet and in the desired position

against the wall. Ensure the heater is based on a ﬁ rm

level surface at least 75mm from any end wall and at least

250mm below any shelf or similar projection. Cut away any

gripper rod or carpet which would prevent the heater sitting

ﬁ rmly on the ﬂ oor.

Mark the position of the two outside corners of the wall

bracket with the heater pushed tight against the wall.

Remove the wall bracket from the heater by removing

the screw at each end. Place the heater to one side and

reposition the bracket against the wall using the corner marks

for alignment.

Four ﬁ xing positions must be chosen for the 724N, three for

the 718N and two for the 712N and 706N. Mark the positions

for the ﬁ xing holes - two at the extreme ends and the others

spaced evenly between them. Remove the bracket from

the wall, drill the holes in the positions marked, and insert

suitable ﬁ xings previously described. Secure the wall bracket

to the wall.

If mains connection is to be made from the left side, at

this point the mains lead must be secured to the back of

the heater using ties provided in the ﬁ xing kit.