Ariklima ARICOOL3C 사용 설명서 - 페이지 2

{카테고리_이름} Ariklima ARICOOL3C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariklima ARICOOL3C 6 페이지.

I. Functions

Note: the instruction describes all the functions. The users can choose

them according to the actual product function.

On/off: when the fan is on standby, pressing the button means "on",

and low-end average wind is set default with negative ion being

working state; while the fan is in the operating state, pressing the

button means "off", the fan stops working, and all lights go out, then

the fan is on standby.

Wind speed/shift: in the working state, wind speed can be regulated

by pressing the button; if the button is pressed repeatedly, air supply

model can be chosen including three models, namely low-

medium-high.

Swing: in the working state, horizontal automatic air supply can be

realized by pressing the button; but the air supply will be halted when

the button is pressed once again.

Cooling: in the working state, pressing the button means to start the

cooling function, and when pressing it again, the cooling function

ceases. (If the fan is devoid of water, the button is void)

Timing: in the working state, if the button is pressed, timer can be

activated and if pressed repeatedly can be adjusted as follows:

→1hour→2hours→... ... →12 hours.

Natural wind: in the working state, the natural wind can be set by

pressing the button. When pressing it again, the natural wind can be

ceased while the wind speed is turned into low speed. (The wind

speed is void in the natural wind model)

Ionizer: in the working state, press the button and the ionizer is

turned off; press the button again and the ionizer is turned on.

★★★Attention:

If water is not sufficient, the pump will immediately stop, the buzzer

goes on and water adding light or cooling light illuminate naturally.

★★★Attention:

Keep the unit out of children's reach. Always let an adult to

supervise the children whenever they operate the unit.

Ensure that the power supply is disconnected when moving and

cleaning the unit.