Dimplex DS2307 서비스 매뉴얼 - 페이지 11
{카테고리_이름} Dimplex DS2307에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex DS2307 11 페이지. Compact stove
Dimplex DS2307에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 문제 해결 매뉴얼 (4 페이지)
페이지 인쇄
- 1. Model Number
- 2. Table of Contents
- 3. Operation
- 4. Maintenance
- 5. Exploded PARTS Diagram
- 6. Wiring Diagram
- 7. Switch REPLACEMENT - UNITS with Thermostat
- 8. Thermostat CONTROL REPLACEMENT
- 9. Switch REPLACEMENT - UNITS Without Thermostat
- 10. Flicker Motor/Flicker ROD REPLACEMENT
- 11. Heater Assembly REPLACEMENT
- 12. Power Cord Replacement
- 13. Troubleshooting Guide
PROBLEM
heater
Heater is not turning off
Heater is not turning on
Heater is turning off after a
couple of minutes of operation
Heater emits an odor
Heater fan turns on but heater
lacks heat
Heating element is glowing red
Heater fan runs continuously
Noise
Excessive noise with the heater
on
Grinding or excessive noise with
the heater off
CAUSE
Improper operation
Defective Heater On/Off Switch
Defective Thermostat
Defective Remote Control Receiver
Improper operation
Defective Heater On/Off Switch
Defective Thermostat
Defective Heater Assembly
Build up of dirt/dust in Heater Assembly
Defective Heater Assembly
Normal Operation
Defective Heater Assembly
Improper operation
Loose wiring
Defective Thermostat
Defective Heater Assembly
Normal Operation
Defective Heater Assembly
Loose wiring
Defective Heater On/Off Switch
Defective Heater Assembly
Defective Thermostat
Dirty Heater Assembly
Defective Heater Assembly
Flicker rod hitting or rubbing against
internal components
Defective flicker motor
SOLUTION
Refer to Operation Section
Replace Heater On/Off Switch
Replace Thermostat
Replace Remote Control Receiver. Initialize to remote
control
Refer to Operation Section
Replace Heater On/Off Switch
Replace Thermostat
Replace Heater Assembly
Ensure that exterior intake louvers and firebox cavity
are free of dirt/dust.
Replace Heater Assembly
Normal operation is when the heater emits an odor
for a brief period after the heater is initially turned on.
The heater is burning off any dust accumulated during
manufacturing or operation.
Replace Heater Assembly
Refer to Operation Section
Trace wiring in unit
Replace Thermostat
Replace Heater Assembly
Small glowing sections of the element are considered
normal.
If larger glowing sections are causing the heater to trip
the thermal cutout, unplug unit, discontinue use and
replace Heater Assembly.
Trace wiring in unit
Replace Heater On/Off Switch
Replace Heater Assembly
Replace Thermostat
Ensure that exterior intake louvers and firebox cavity
are free of dirt/dust.
Replace Heater Assembly
Ensure rod is straight and mounted properly in the
bracket, spinning freely away from other components.
Replace if necessary.
Replace flicker motor
11