Dimplex ELECTRALOG CS1205 서비스 매뉴얼 - 페이지 10
{카테고리_이름} Dimplex ELECTRALOG CS1205에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex ELECTRALOG CS1205 16 페이지. Electric stove
Dimplex ELECTRALOG CS1205에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (11 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Operation
- 3. Replacement Parts
- 4. Wiring Diagram
- 5. To Replace Light Bulbs
- 6. To Replace Lampholders
- 7. To Replace On/Off and Heater Switches
- 8. To Replace Heater Assembly
- 9. To Replace Terminal Block
- 10. To Replace Flame Motor/Flame Rod
- 11. To Replace the Power Cord
- 12. Troubleshooting Guide
CS1205
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE HEATER ASSEMBLY
1. Turn the stove over and place it top down.
2. Remove the bottom heater assembly cover being careful not to damage any of the
wiring.
3. Remove the 4 heater retaining screws from the bottom of the heater assembly cover
and move the heater to gain access to the heater connections being careful not to
damage any of the wiring.
4. Disconnect the 2 heater switch leads from the heater.
5. Remove the wire nut and disconnect the thermal cut-out wire.
6. Remove the 2 mounting brackets from the bottom of the old heater and install them
on the new heater.
7. Reassemble in the reverse order as above.
9