Dimplex ELECTRALOG CS3311 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Dimplex ELECTRALOG CS3311에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex ELECTRALOG CS3311 13 페이지. Compact stove
Dimplex ELECTRALOG CS3311에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (11 페이지), 부품 및 서비스 매뉴얼 (12 페이지), 서비스 매뉴얼 (13 페이지)
페이지 인쇄
Troubleshooting Guide
PROBLEM
General
Circuit breaker trips or fuse
blows when unit is turned on
Unit turns on or off by itself
Lights dim in room while the unit
is on
Power cord gets warm
Appearance
Fireplace does not turn on Manu-
ally
Fireplace does not turn on using
the Remote Control
Flame Frozen
Flame not bright or flame not
visible
Log set dim, not glowing
Flame Shudder
Light leaking around the log set
CAUSE
Short in unit wiring.
Improper circuit current rating
Remote Control has a similar frequency to
other remotes in the area.
Radio frequency disturbance from outside
sources.
Unit is drawing close to circuit current
rating
Normal Operation
Defective power cord
Improper operation
No incoming voltage from the electrical
wall socket
Loose wiring
Defective On/Off or 3-Position Switch
Defective Remote Control Receiver
Improper operation
Remote Control not initialized to fireplace
Remote Control not working.
Loose wiring
Defective Flicker motor
Burnt out light bulbs
Loose wiring
Defective light harness
Burnt light bulbs
Defective Flicker motor
Log set not positioned properly
Trace wiring in unit.
Additional appliances may exceed the current rating of
the circuit breaker or fuse. Plug unit into another outlet
or install unit on a dedicated 15 amp circuit.
Replace Remote Control. Initialize Remote Control and
Remote Control Receiver
Replace Remote Control and Remote Control Receiver,
where necessary. Initialize Remote Control and Re-
ceiver
Move the unit to another outlet or install unit on a dedi-
cated 15 amp circuit
The power cord may get slightly warm to the touch when
the heater is on
Replace power cord if cord gets hot to the touch.
Refer to Operation Section
Check Fuse/Breaker Panel
Check wiring connections
Replace On/Off or 3-Position Switch (Depending on the
model)
Replace Remote Control Receiver. Initialize with Re-
mote Control
Refer to Operation Section
Initialize the Remote Control
Install new battery into the Remote Control. Reinitialize
remote where necessary
Replace Remote Control or Remote Control Receiver,
where necessary. Initialize Remote Control and Re-
ceiver.
Check wiring connections
Replace Flicker motor
Replace light bulbs
Check wiring connections
Replace light harness
Replace light bulbs
Replace Flicker motor
Check log set for proper fit
12
SOLUTION