Dimplex MILANOef EDS7001F 부품 및 서비스 매뉴얼 - 페이지 14

{카테고리_이름} Dimplex MILANOef EDS7001F에 대한 부품 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex MILANOef EDS7001F 17 페이지. Dimplex milano stove parts and service manual
Dimplex MILANOef EDS7001F에 대해서도 마찬가지입니다: 부품 및 서비스 매뉴얼 (17 페이지)

페이지 인쇄

EDS7001F MILANO

If the stove was operating prior to servicing allow at least 10 minutes for light

bulbs and heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the

risk of electric shock or damage to persons.

TO REPLACE POWER CORD

1. Remove the stove pipe kit (if equipped).

2. Unscrew the two black knobs on the front of the unit by turning

counterclockwise.

3. Grasp onto the front door, gently lift up and pull the door off of the unit.

4. Remove the upper light bracket mounting screws from the top and remove

the light bracket assembly from the unit.

5. Locate the four cam locks on the side panels inside the upper corners of

the stove and turn with a large slot screwdriver so the triangle on the cam

lock is pointing up towards the top of the stove.

6. Grasp the top at both sides and gently pull to release the top.

7. Remove the four screws from the rear panel.

8. Locate the main on/off switch mounted on the rear panel and disconnect

the wiring connections noting their original locations.

9. Slide the rear panel up approximately three inches.

10. Locate and remove the wiring connections for the power cord.

11. With needle nose pliers grasp the power cord strain relief grommet from

inside the rear cover and push while twisting to remove.

12. Pull the old power cord out through the rear cover.

13. Install the new power cord through the hole in the rear cover and connect

all of the wiring connections in their original locations.

14. Install the power cord retaining grommet on the power cord and insert into

the hole in the rear cover.

15. Reassemble in the reverse order as above.