Dimplex CUH05B31T 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Dimplex CUH05B31T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex CUH05B31T 20 페이지. Compact unit heater
Dimplex CUH05B31T에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (6 페이지), 소유자 매뉴얼 (9 페이지), 소유자 매뉴얼 (9 페이지)

페이지 인쇄

1. Heater Installation

Heater Installation

or tilting the heater do not block the

exhaust opening.

The following steps are shown in

Figure 3:

1. Locate a stud or other suitable

support and install hanger bracket

on wall or ceiling. Select location

so control knob on back of heater

can be reached easily. *

2. Insert carriage bolt into square

opening of heater handle.

3. Slide spacer over the carriage bolt

shaft and insert in hanger bracket

opening and hold them in position.

4. Slide lock washer and thread nut

onto carriage bolt, turn and tighten

with wrench.

* DO NOT INSTALL LESS THAN 6

FT (1.9m) FROM THE FLOOR

ELECTRICAL CONNECTION

WARNING: Consult local electri-

cal codes in addition to the follow-

ing requirements:

1. Turn off main power supply at the

electrical panel.

2. Route supply wires from circuit

breaker to an approved junction

box, located near compact unit

heater. Each heater should be

on an individual, properly fused

circuit.

3. Route supply wires from junction

box to CUH. Supply wires from

junction box to heater must be two

conductor metallic sheath (BX)

cable with ground wire. Alterna-

tively, appropriate conduit can be

used.

4. Remove junction box cover of

CUH and remove one knockout

hole. Insert approved bushing

into hole and feed wire cable

through. Tighten bushing around

cable.

5. Make electrical connection to

CUH according to relevant wire

diagram. Make connections using

approved wire nut connectors

and secure the grounding wire to

the ground screw on the heater

chassis.

NOTE: The onboard thermostat

can be bypassed, to allow for opera-

tion with a wall mounted thermostat.

To do this disconnect the wires from

the onboard thermostat and join them

with a wire connector.

6. Replace junction box cover of

CUH.

Wiring

GROUND

ELEMENT

THERMOSTAT

CYCLE

OFF

CUT-OUT

FAN DELAY

OVER TEMP.