Crutchfield 016 0045 마스터 시트 - 페이지 3

{카테고리_이름} Crutchfield 016 0045에 대한 마스터 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Crutchfield 016 0045 8 페이지. For dodge dakota

016 0045

Receiver Installation

1. Secure receiver mounting bracket to

dash with screws previously removed from

factory radio.

2. Connect receiver wiring adaptor to receiver

following instructions supplied with wiring

adaptor (see note on the right).

3. Remove DIN sleeve from receiver

(Figure 1).

4. Slide DIN sleeve into mounting bracket and

secure to bracket by bending the securing

tabs (Figure 2).

5. Hold receiver near dash. Connect receiver

wiring adaptor to factory harness. Plug

antenna lead into rear of receiver.

6. Slide receiver fully into sleeve and test

operation.

7. Reassemble dash by reversing

disassembly steps.

1-800-955-9094

Technical Service

Note: If vehicle is factory equipped with

Infinity System amplifier, the amplifier may

be used with the aftermarket receiver.

Simply connect the power antenna lead on

the Crutchfield wiring adaptor (harness) to

the power antenna or amp remote lead of the

aftermarket receiver.

Receiver Mounting Bracket

NOTES:

• Inspect factory receiver harness connector in vehicle.

Ensure that the wiring adaptor received from

Crutchfield plugs into the vehicle's connector. If the

connector is missing or incorrect, please call our

Technical Service Department at 1-800-955-9094.

FIGURE 2

FIGURE 1

DIN Sleeve

Securing Tabs

Bend tabs after sleeve

is inside mounting bracket.