Aeon Labs AEOEZW100 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Aeon Labs AEOEZW100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs AEOEZW100 11 페이지. Routing multisensor
페이지 인쇄2
enable, the current PIR sensitivity level = 2.
3
enable, the current PIR sensitivity level=3.
4
enable, the current PIR sensitivity level=4.
5
enable, the current PIR sensitivity level=5. (maximum level)
command sent when the motion sensor triggered. (Parameter Number 5, Parameter Size
motion sensor triggered.
Value
Description
1
send Basic Set CC.
2
send Sensor Binary Report CC.
low battery value. (Parameter Number 39, Parameter Size
Value
10 — 50
selective reporting (Parameter Number 40, Parameter Size
certain threshold or percentage set in 41-44 below. This is used to reduce network traffic.
Value
0
1
Threshold change in temperature to induce an automatic report. (Parameter Number 41, Parameter Size
Celsius, threshold=Value. 2. When the unit is Fahrenheit, threshold=Value*1.8. The accuracy is 0.1. 3. The high byte is the part of integer,
the low byte is the fractional part.
Value
Threshold change in humidity to induce an automatic report. (Parameter Number 42, Parameter Size
high byte is the part of integer, the low byte is the fractional part.
1)Configure low battery value.
Description
default value = 20 %
1)Enable/disable the selective reporting only when measurements reach a
Description
disable (Default)
enable
Description
1)Which command would be sent when the
2)1. When the unit is
2)The accuracy is 0.1. The