Dimplex RKHA 매뉴얼 - 페이지 3

{카테고리_이름} Dimplex RKHA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex RKHA 4 페이지. Under cabinet heater
Dimplex RKHA에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 소유자 매뉴얼 (3 페이지), 사용 설명서 (10 페이지), 매뉴얼 (4 페이지)

페이지 인쇄

Maintenance

WARNING: Disconnect power and allow heater to cool

before attempting any maintenance or cleaning to reduce

the risk of fire, electric shock, or injury to persons.

Remove grille and frame by removing screws "A". Remove

two screws "B", and slide out heating assembly. When

re-assembling, reverse the procedure above.

Cleaning

NOTE: This heater should not be operated with an

accumulation of dust or dirt on or in the unit, as this can

cause a build-up of heat and eventual damage. For this

reason the heater must be inspected regularly, depending

upon conditions and at least at yearly intervals.

FIGURE 5

Factory Wiring

208/240 675/900 WATTS

3.2 A / 3.7A

FAN

IMPORTANT: Terminate unused leads with wire nuts and

retighten all leads with cable clamp

NOTE: See supplemental wiring diagram for thermostat wiring, Figure 5a.

Field Wiring

208/240 1350/1800 WATTS

6.5 A / 7.5 A

FAN

Safety Switch

•

With grille in place - Use vacuum cleaner hose to suck

out lint and dirt around grille. Reverse hose on vacuum to

use as a blower to move dust out of enclosure. Reverse

hose back to suck out dirt at front area of heater.

•

With grille removed - Remove two screws "B" at bottom

front of heating element assembly. Pull gently to remove

it from enclosure. Swing assembly out. Vacuum inside of

enclosure and around heating element assembly. Reverse

procedure above to re-assemble unit.

FAN

Safety Switch

Field Wiring

120 V

Safety Switch

RATING

CONNECT

450W / 3.75A

7-8 (AS SHOWN)

900W / 7.5A

7-8, 1-2

1350W / 11.2A

7-8, 1-2, 3-4

1800W / 15A

7-8, 1-2, 3-4, 5-6

FIGURE 5a

THERMOSTAT