Aeon Labs Aeotec Water Sensor 6 매뉴얼 - 페이지 6

{카테고리_이름} Aeon Labs Aeotec Water Sensor 6에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec Water Sensor 6 12 페이지. Z-wave water sensor

페이지 인쇄

1, This procedure should only be used when the primary controller is inoperable.

2, Reset Water Sensor to factory default settings, it will:

a ), let the Water Sensor to be excluded in Z-Wave network;

b), delete the Association settings;

c), restore the Configuration settings to the default.

5. Special rule of each command

5.1 Basic Command Class

When the water sensor is triggered, it will send the Basic Set 0x00/0xFF (configured by parameter 0x58 and

0x59) to the associated nodes in association group 3 or 4.

Basic Report = 0x00, Water Leak Cleared.

Basic Report = 0xFF, Water Leak Detected

5.2 Z-Wave Plus Info Report Command Class

Parameter

Z-Wave Plus Version

Role Type

Node Type

Installer Icon Type

User Icon Type

5.3 Manufacturer Specific Report

Parameter

Manufacturer ID 1

Manufacturer ID 2

Product Type ID 1

Product Type ID 2

Product ID 1

Product ID 2

5.4 Association Command Class

Water Sensor 6 supports 4 association groups and can add max 5 nodes for every group.

Association

Nodes Send

Group

Group 1

[1,5]

(Lifeline)

Value

6 (ZWAVEPLUS_INFO_REPORT_ROLE_TYPE_SLAVE_ALWAYS_ON)

0 (ZWAVEPLUS_INFO_REPORT_NODE_TYPE_ZWAVEPLUS_NODE)

0x0C07 (ICON_TYPE_SPECIFIC_SENSOR_NOTIFICATION_HOME_SECURITY)

Value

AEON LABS=0x00

AEON LABS=0x86

EU=0x00, US=0x01, AU=0x02 CN=0x1D (29)

0x02

0x00

0x7A (122)

Send commands

Mode

Single Cast

Send Battery Report or Multilevel Sensor Report (configured

by parameter 0x65 and 0x6F).

Send Notification Report when water leak is detected.

Note:

group, the Water Sensor will send the "Water leak detected"

notification if any of the probes detect water and "event

cleared" notification if none of the probe longer detects a

When having a classic Node ID association on this

Page 6