Dimplex XLS18N 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Dimplex XLS18N에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex XLS18N 8 페이지. Ultra-slim storage heaters
Dimplex XLS18N에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지), 운영 지침 (4 페이지), 설치 지침 매뉴얼 (8 페이지), 운영 지침 (4 페이지), 설치 지침 매뉴얼 (8 페이지)
페이지 인쇄
16. Remove bottom front panel securing screws. These
were loosened in step 4 and should be easily unscrewed
by hand.
14. If left hand cable connection is required, the cable
support straps supplied in the fixing kit should be fitted to
the base of the rear of the heater, and the supply cable fed
through them. Ensure sufficient spare cable is fed through
the straps to make the mains connection.
15. Secure heater to wall fixing bracket by replacing the two
screws removed in step 10 (do not fully tighten these screws
until the bricks are loaded into the heater as some settling of
the heater may occur). The feet and wall mounting arrangement
are designed to accommodate skirting board sizes up to
25mm (1") thick. To avoid obstructing the airflow to the rear
of the heater the following must be strictly adhered to:
(a) For skirtings higher than 100mm (4") it will be necessary to
position the heater with the screws attached through the
alternative fixing slots to the front.
(b) For skirtings having a height in excess of 150mm (6") it will
be necessary to reduce the height of the skirting to 150mm
(6") over the entire length of the heater plus 25mm (1") at either
end.
17. Pull bottom of front panel forward to disengage it from
bottom of heater.