Crux SWRGM-49 매뉴얼 - 페이지 2

{카테고리_이름} Crux SWRGM-49에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crux SWRGM-49 5 페이지. Radio replacement interface for gm lan 29 bit vehicles 2006-2015

SETTING THE AFTERMARKET RADIO BRAND

With the key in the off position, set the DIP switches to the corresponding radio listed below.

3.5MM SWC CABLE

The SWRGM-49 Module allows for both types of connections:

OPTION A is used for ALPINE, CLARION, (JVC and KENWOOD units will use the Blue/Yellow wire).

OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and

SOUND STREAM units.

NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

If the vehicle is equipped with a Bose system, the SWRGM-49 has a built-in Bose adaptor that allows the proper

audio input gain from the aftermarket radio to the Bose amplifier. To use this feature, plug in the male 8-pin

connector on the harness to the GRAY female 8-pin connector on the GM-49 module. The module is also labeled

"Bose" and "Non Bose" to avoid confusion. (see picture below)

If the vehicle is NOT equipped with a Bose system, plug in the male 8-pin connector to the BLACK female 8-pin on

the GM-49 module.

Non-BOSE

Connection

BOSE

Connection

2 / 5

Rev.050918