Dimplex DCPF40CH 사용 설명서 - 페이지 5

{카테고리_이름} Dimplex DCPF40CH에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex DCPF40CH 7 페이지. 40cm hv pedestal fan
Dimplex DCPF40CH에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

Assembly

Lastly, attach the fan head to the motor - refer to Fig. 3 & the instructions below:

1. Remove the protective sleeve from the motor shaft (12) and the four fixing

screws from the motor housing. Attach the rear guard (4) to the motor housing

(9) using the four screws you just removed. Ensure the handle is at the top.

2. Place the fan blade (3) over the motor shaft (12) and tighten the fan blade

screw completely, ensuring that it tightens against the flat part of the motor

shaft.

3. Remove the front guard screw and nut (2, 5) from the front guard and release

the guard retaining clips (14) around the outside edge outwards.

4. Hang the front guard (1) by its hook over the top of the rear guard (4). Bring the

front guard down to meet the rear guard and fit the guard screw (2) through

the holes in the bottom edge of the guard and tighten with the nut (5). Finally

push the clips inwards until the front guard is attached to the rear guard.

Operation

1. Place the fan on a firm level surface. Connect the plug to a power supply and

switch on the power.

2. Turn the fan ON by rotating the speed control knob on the motor housing in

clockwise direction.

3. The fan has 3 SPEEDS to choose from, "1" - Low, "2" - Medium, "3" - High.

4. The airflow direction can be adjusted upward/downward by lifting up or pressing

down the motor housing.

NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your

fingers through the guard.

5. Push the oscillating knob on the motor housing down to start OSCILLATION. Pull

the oscillation knob up to stop OSCILLATION.

6. Turn the speed control knob anti-clockwise to the "0" position to turn the fan

OFF.