Dimplex DCPF40MBK 사용 설명서 - 페이지 4

{카테고리_이름} Dimplex DCPF40MBK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex DCPF40MBK 7 페이지. 40cm hv pedestal fan

페이지 인쇄

Parts

Fan blade

Retaining clip

Front guard

Fixing screws

Fan blade screw

Screw

Rear Guard

Motor shaft

Speed control

Motor housing

Adjustment knob

Bolt

Pivot knob

Upper pillar

Nut

Neck Retaining

screw

Height adjustment

knob

Main pillar

Stand base

Weight

Clamping washer

L-shaped screw

Speed control

Assembly

First assemble the base to the main pillar - refer to Fig. 1 & instructions below:

1. First unscrew the L-shaped screw (18) and remove it and the clamping washer

(17) from the bottom of the main pillar (6).

Power cord

2. Turn over the stand base (15). Place the weight (16) in its place on the underside

of the base and place the clamping washer (17) in the centre of the weighted

base (16).

3. Thread the L-shaped screw (18) through the assembly and into the thread of

the main pillar (6). Tighten firmly, but do not overtighten.

4. Loosen the height adjustment knob and pull the upper pillar out of the main

pillar and secure the knob to the desired height.

Secondly, attach the motor housing to the base & upper/main pillar - refer to Fig 2

& the instructions below:

1. First remove the pivot knob (7) and the bolt (20) from the top of the upper

pillar (6), then remove the neck retaining screw (8) and small adjustment knob

(19) from the motor housing bracket.

2. Place the motor housing on the top of the upper pillar and thread the large

pivot bolt (20) through the bracket. Screw in the small retaining screw (8) and

tighten, but do not overtighten.

3. Fit the large pivot knob (7) onto the end of the bolt (20) and the small

adjustment knob (19) at the other side above the bolt. Tighten the knobs while

holding the fan motor upright.