Aeon Labs Z-Stick 운영 지침 - 페이지 4

{카테고리_이름} Aeon Labs Z-Stick에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Z-Stick 5 페이지. Z-wave usb adapter

(The LED on the Z-Stick will immediately stay solid for 3 seconds to indicate

successful removal from the network.)

3. The LED will then return to blinking fast, indicating readiness for further

device exclusions. Repeat step 2 for each device as you wish to exclude.

4. Tap the Z-Stick button to turn off.

• SerialAPI-Mode : Allowing a Host Processor To Take Control of the Z-Stick and

Take Part in the Z-Wave Network

1. To initiate SerialAPI-Mode, plug the Z-Stick into the USB connector of the

host.

Note: While in SerialAPI-mode, the Z-Stick is always listening (it is awake

and always in RX receive mode) for instructions and acts as a Z-Wave

adapter and responds to commands sent through USB by the host

processor software.

Note: Pressing the Z-Stick button will not have any effect while in SerialAPI-

Mode.

• Other Functions:

• Factory reset on the Z-Stick: This must be done through the host software

which takes control of the Z-Stick USB adapter while the Z-Stick is in

SerialAPI-Mode. Please consult the instruction manual of the host software

to perform a network reset (i.e. factory reset on the Z-Stick). This function

can only be preformed via the host software.

• Add the Z-Stick to a pre-existing Z-Wave network: This must be done

through the host software which takes control of the Z-Stick USB adapter

while the Z-Stick is in SerialAPI-Mode. Please consult the instruction manual

of the host software to add the Z-Stick to a pre-existing Z-Wave network

(i.e. "Learn", "Sync", "Add as Secondary Controller", etc.). This function

can only be preformed via the host software.

• Device Firmware Update: Download the new device firmware from

www.aeon-labs.com, then insert z-stick to USB port, and held down the z-

stick button for entire update process.