Aeon Labs Aeotec 사용자 설명서 - 페이지 10
{카테고리_이름} Aeon Labs Aeotec에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec 11 페이지. Home energy meter
Aeon Labs Aeotec에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
17.09.2018
If you're using a Z-Stick:
1. If your Z-Stick is plugged into a gateway or a computer, unplug it.
2. Take your Z-Stick to your Garage Door Controller.
3. Press the Action Button on your Z-Stick.
4. Press the Z-Wave Button on your Garage Door Controller.
5. If your Garage Door Controller has been successfully removed from your network, its Network LED will blink. If the
removal was unsuccessful, the Network LED will not blink.
6. Press the Action Button on the Z-Stick to take it out of removal mode.
If you're using a Minimote:
1. Take your Minimote to your Garage Door Controller.
2. Press the Remove Button on your Minimote.
3. Press the Z-Wave Button on your Garage Door Controller.
4. If your Garage Door Controller has been successfully removed from your network, its Network LED will blink. If the
removal was unsuccessful, the Network LED will not blink.
5. Press any button on your Minimote to take it out of removal mode.
Reset your Garage Door Controller.
If your primary controller is missing or inoperable, you may wish to reset your Garage Door Controller to its default
factory settings. To do this:
Press and hold the Z-Wave Button for 20 seconds and then release it.
https://aeotec.freshdesk.com/support/solutions/articles/6000053811-garage-door-controller-gen-5-user-guide-
Garage Door Controller Gen5 user guide. : Aeotec by Aeon Labs
10/11