Dimplex RLG20FC 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Dimplex RLG20FC에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex RLG20FC 18 페이지. 20 electric log set
Dimplex RLG20FC에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

Dimplex RLG20FC 서비스 매뉴얼
Operation
RLG20BR, RLG20FC, RLG25BR,
RLG25FC
Manual Control
The manual controls for the Revillusion are located on the
right-front leg of the log grate.
Power
Press to turn the flame effect on and activate the
previous heat setting (Off, Low, or High). Press again
to put the unit in standby mode.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat Off
Press to turn heat Off (indicated by 1 long beep).
!
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off. The
log LEDs remain On when the heater is ON and the
flame effect is Off.
!
NOTE: The heater will only turn on when the flame
effect is on.
360
Light
o
Press multiple times to change the LEDs on the
sides and back of the unit from white flickering to
white solid to Off. (This feature is active only when
the flame effect is On.)
Brightness
Press multiple times to toggle the log set LEDs
through its four brightness settings.
Remote Control
The fireplace is supplied with a multi-function remote con-
trol.
The remote control has a range of approximately 30 ft (9
m). To operate correctly, the remote control must be pointed
toward the front of the unit.
Power
Press to turn the flame effect on and activate the
previous heat setting (Off, Low, or High). Press again
to put the unit in standby mode.
Flame
Press to light the back log, grate log, and ember mat,
and start the flame effect.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat Off
Press to turn heat Off (indicated by 1 long beep).
!
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off. The
log LEDs remain On when the heater is ON and the
flame effect is Off.
!
NOTE: The heater will only turn on when the flame
effect is on.
360
Light
o
Press multiple times to change the LEDs on the
sides and back of the unit from white flickering to
white solid to Off. (This feature is active only when
the flame effect is On.)
Brightness
Press multiple times to toggle the log set LEDs
through its four brightness settings.
5