DimSport My Tuning Bike 사용 설명서 - 페이지 4
{카테고리_이름} DimSport My Tuning Bike에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DimSport My Tuning Bike 6 페이지. Device for permanent auto mapping function with bosch wideband o2 sensor
페이지 인쇄
Disable the feature "Average cell" removing the flag in "RB Features
rows\columns".
If the Rapid Bike module is set for a switch map the adjustments will be only calculated for the map 1.
The switch map will not switch between map 1 and map 2 but it will turn on/off the My Tuning Bike
(position map 1 = ON, position map 2 = OFF)..
If the My Tuning Bike is turned off the injection trim map won't be modified again but its values will be
used to adjust the base map during driving.
1. Turn on ignition, the blue led and the red led must turn
on:
Blue led => connection established with RB module.
Red led => 12V power supply ok.
2. Turn on the engine, the My Tuning Bike will
automatically start to heat the O2 sensor.
3. Then the Rapid Bike module will wait until three
conditions are satisfied:
a) The My Tuning Bike O2 sensor has reached the operating temperature (the red led starts to flash).
b) If the OEM O2 sensor is installed and it is hot and works properly. The blue sign will appear on the
down side of the AFR display to confirm this condition.
If the OEM O2 sensor is not installed,
deselect the RB-O2 function that is in
Auto-adaptivity.
c) The engine has exceeded 4500 rpm/min.
The purpose is to avoid adjustments while the engine is working in
unstable conditions (engine heating, etc.).
Once the three conditions are satisfied the adjustments will be performed for RPM values higher than the
one set for the option Start correction.
If the My Tuning Bike is connected to a RapidBike Racing module it is strictly necessary that the RB
wiring is connected properly to the crankshaft position sensor.
4. After the driving session, the injection trim map can be checked by downloading the map from the
RapidBike module and selecting the form My Tuning Bike.
The injection trim map can be erased by clicking on Reset Maps or it can be added permanently to the
base map by right-clicking on a cell and select Add correction (then the trim map will be erased).
If the RapidBike maps are configured with one map for each injector the My Tuning Bike will use only
one trim map that will be applied on each injection map.
Issued by: PM
Operating and checks
approved by DG
WARNING
Warning
Rev.07
Map configuration
date 12/06/16
pag. 4/6