Pioneer APP Radio 3 설치 매뉴얼 - 페이지 4

{카테고리_이름} Pioneer APP Radio 3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer APP Radio 3 48 페이지. In-dash iphone and android compatible car receiver with 7" capacitive multi-touchscreen, dvd/cd player, bluetooth, mirrorlink, and on-screen access to compatible apps

페이지 인쇄

Chapter

Connecting the system

Precautions before

connecting the system

WARNING

Do not take any steps to tamper with or

disable the parking brake interlock sys-

tem which is in place for your protec-

tion. Tampering with or disabling the

parking brake interlock system could

result in serious injury or death.

CAUTION

• If you decide to perform the installa-

tion yourself, and have special training

and experience in the mobile electron-

ics installations, please carefully fol-

low all of the steps in the installation

manual.

• Secure all wiring with cable clamps or

electrical tape. Do not allow any bare

wiring to remain exposed.

• Do not directly connect the yellow lead

of this product to the vehicle battery. If

the lead is directly connected to the

battery, engine vibration may eventu-

ally cause the insulation to fail at the

point where the wire passes from the

passenger compartment into the

engine compartment. If the yellow

lead's insulation tears as a result of

contact with metal parts, short-circuit-

ing can occur, resulting in considerable

danger.

• It is extremely dangerous to allow

cables to become wound around the

steering column or shift lever. Be sure

to install this product, its cables, and

wiring away in such so that they will

not obstruct or hinder driving.

• Make sure that the cables and wires

will not interfere with or become

caught in any of the vehicle's moving

parts, especially the steering wheel,

shift lever, parking brake, sliding seat

tracks, doors, or any of the vehicle's

controls.

• Do not route wires where they will be

exposed to high temperatures. If the

insulation heats up, wires may become

damaged, resulting in a short circuit or

malfunction and permanent damage to

the product.

• Do not cut the GPS antenna cable to

shorten it or use an extension to make

it longer. Altering the antenna cable

could result in a short circuit or mal-

function.

• Do not shorten any leads. If you do, the

protection circuit (fuse holder, fuse

resistor or filter, etc.) may fail to work

properly.

• Never feed power to other electronic

products by cutting the insulation of

the power supply lead of this product

and tapping into the lead. The current

capacity of the lead will be exceeded,

causing overheating.

Before installing this product

• Use this unit with a 12-volt battery and

negative grounding only. Failure to do so

may result in a fire or malfunction.

To avoid shorts in the electrical system, be

sure to disconnect the (−) battery cable be-

fore installation.