Aeon Labs Aeotec 사용자 설명서 - 페이지 5
{카테고리_이름} Aeon Labs Aeotec에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec 7 페이지. Home energy meter
Aeon Labs Aeotec에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
10/19/2017
Your Panic Button is in Use (Group) Mode.
In order to program each button of your Panic Button, please refer to the 'Selecting which devices to control' section of
this guide.
Your Panic Button is in Use (Scene) Mode.
In this mode, your Panic Button communicates directly with your Z-Wave network's primary controller, generally a
gateway or hub. By pressing each scene button, your Panic Button will send out a scene ID telling the primary controller
to activate customized scenes that need to be setup via your controller's interface. Please refer to your primary
controller's user manual for instructions on how to program individual scenes and how to activate these with your Panic
Button.
Using your Panic Button.
With your Panic Button now setup, it's time to use it. That's as simple as pushing a button to activate or deactivate
scenes. If your Panic Button is in Use (Scene) Model, the following table illustrates the button presses your remote will
understand in order to control 2 different scenes with its button.
Advanced functions.
Adding devices to your Z-Wave network.
Panic Button can be used to create a new Z-Wave network and in which Panic Button will serve in place of a Z-Wave
gateway or control software. The following instructions will guide you through creating such a network where Panic Button
can communicate with connected Z-Wave devices.
To create this network, you will connect Z-Wave devices directly to Panic Button. These devices cannot be a part of an
existing network and may have to be factory reset if they have been previously used.
1. Quickly press Include/Remove on back of Panic Button with provided Pin.
2. Press the join network / Action Button on the Z-Wave device that you want to add to Panic Button's network. If you
are unsure which button to press, please refer to the Z-Wave product's instruction manual.
3. When the Z-Wave product successfully joins Panic Button's network, Panic Button's LED will flash green slowly and
then turn solid green for 2 seconds. Should the LED continue to flash green for a further 30 seconds before turning
off, the Z-Wave product has been unable to connect to Panic Button; repeat the above steps and please contact us
for further support if needed.
4. Repeat step 2 to connect any other devices you would like to add into the network.
5. Once finished, press Panic Button's Action Button to exit Include/Remove mode.
You have now created a Z-Wave network in which Panic Button serves as the main controller. You now need to program
Panic Button's specific control of these devices. To do this, please follow the instructions in the "Selecting which devices to
control." section of this guide.
Removing devices from your Z-Wave network.
https://aeotec.freshdesk.com/support/solutions/articles/6000177086-panic-button-user-manual-
Panic Button user manual. : Aeotec by Aeon Labs
5/7