Pioneer AVIC-5100NEX 설치 매뉴얼 - 페이지 28
{카테고리_이름} Pioneer AVIC-5100NEX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVIC-5100NEX 34 페이지. System firmware update instructions
Pioneer AVIC-5100NEX에 대해서도 마찬가지입니다: 펌웨어 업데이트 매뉴얼 (7 페이지), 운영 매뉴얼 (10 페이지)
페이지 인쇄
Section
03
Installation
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot — for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-6100-
NEX and AVIC-5100NEX.
This product
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
28
En
Do not cover this area.
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw
holes on the side of this product
% Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et's screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
1
2