Din Sync MODSEQ 사용자 설명서 - 페이지 10

{카테고리_이름} Din Sync MODSEQ에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Din Sync MODSEQ 11 페이지.

Mult the /8 division of the clock divider to all the RESET jacks of the MODSEQs and the trigger of

both sequential switches. If you miss this step and depending on which switch used you may

find an extra step is triggered, using the reset keeps everything locked nice and tight.

When you run this patch each MODSEQ will only get a clock when its running for a nice visual

effect.

You can see an example of 4 cascaded MODSEQs towards the end of this video.

http://www.youtube.com/watch?v=aA2YML6T4NQ

If you have one bidirectional sequential switch, setup your patch like this

Mult your clock to all MODSEQs and the clock divider

Connect the MODSEQ outputs to the switch and the single output of the switch to the module

you wish to modulate.

Mult the /8 division of the clock divider to the trigger of the sequential switch.

In this case all MODSEQs will be running and the switch will change the outputs.

MODSEQ as an LFO/Oscillator

You can clock the MODSEQ at audiorates with a fast squarewave and adjust the knobs to make

different waveshapes. While at audiorate the timing isn't very accurate, it can still be a lot of fun

to try!

Paranormal Patroller's Paranormal Drums.

Mult a clock to the MODSEQ CLOCK IN and a 4MS Rotating Clock Divider,

Connect RCD output /8 to MODSEQ CV IN,

Connect MODSEQ CV OUT to RCD Rotate in

Patch RCD outputs to DrumDokta's inputs and twist the MODSEQ knobs.

Try connecting the MODSEQ CLOCK IN to other divisions from the RCD for a twist on this

patch.