Pioneer AVX-P8DVD 운영 매뉴얼 - 페이지 3
{카테고리_이름} Pioneer AVX-P8DVD에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVX-P8DVD 4 페이지. Owner's manual
Pioneer AVX-P8DVD에 대해서도 마찬가지입니다: 설치 매뉴얼 (9 페이지), 소유자 매뉴얼 (34 페이지)
페이지 인쇄
KM161_oper
04.11.24 4:43 PM
Page 5
SIRIUS tuner
Selecting a SIRIUS source
Press SOURCE to select a SIRIUS
source.
Press SOURCE repeatedly to switch between
the following sources:
Built-in CD player—Television—Tuner—
Multi-CD player—SIRIUS tuner (External
unit 1)—External unit 2—AUX
Turning the unit off
Press SOURCE and hold until the unit
turns off.
Listening to SIRIUS
These are the basic steps necessary to oper-
ate the SIRIUS.
1
Press SOURCE to select a SIRIUS
(External) source.
2
Press BAND to select a band.
Press BAND until the desired band is dis-
played, SR1, SR2 or SR3.
3
Press
or
to select a desired chan-
nel.
The channel number move up or down step
by step.
Channels that cannot currently be selected
are skipped, and the next channel is
selected.
If you press and hold
or
, you can
increase or decrease channel number continu-
ously.
You can also select a channel from a desired
channel category. (Refer to "Switching the
channel select mode".)
4
Press SOURCE and hold until the unit
turns off.
SIR-PNR1 Operation Guide
SIRIUS tuner
Notes
• It may take a few seconds before you can
hear anything while this unit acquires and
processes the satellite signal when you turn
power on, change the source to SIRIUS
tuner, or select a channel.
• Display changes as follows when you switch
channels or operate in other ways. The text of
selected display* is automatically scrolled.
Channel number—Channel name—Selected
display *
* For details, refer to "Switching the
display".
Storing and recalling chan-
nels
If you press any of the preset tuning buttons
1–6 you can easily store up to six channels
for later recall with the touch of a button.
• Memory and recall are for broadcasts. If
you recall a memorized broadcast that
has been moved to another channel, the
channel to which the broadcast was
moved is selected.
When you find a channel that you
want to store in memory press a preset
tuning buttons 1–6 and hold until the pre-
set number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected channel has been stored in
memory.
The next time you press the same preset tun-
ing button the channel is recalled from mem-
ory.
Notes
• Up to 18 channels, six for each of the three
bands can be stored in memory.
• When channel number select mode is
selected, you can also use
and
to recall
channels assigned to preset tuning buttons
1–6.
• If a channel you have recalled cannot be
selected, a message is displayed for 2 sec-
onds and the unit returns to the operating
status before the channel was recalled.
SIR-PNR1 Operation Guide