Pioneer CDX-P1270 서비스 수리 교육 - 페이지 37
{카테고리_이름} Pioneer CDX-P1270에 대한 서비스 수리 교육을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer CDX-P1270 50 페이지. Multi-compact disc player
Pioneer CDX-P1270에 대해서도 마찬가지입니다: 소유자 매뉴얼 (4 페이지), 소유자 매뉴얼 (4 페이지), 소유자 매뉴얼 (4 페이지), 소유자 매뉴얼 (18 페이지)
페이지 인쇄
- 1. Table of Contents
- 1. 1 Safety Information
- 2. 2 Exploded Views and Parts List
- 3. 3 Block Diagram and Schematic Diagram
- 3. CD Mechanism Module
- 4. 4 Pcb Connection Diagram
- 5. 5 Electrical Parts List
- 6. 6 Adjustment
- 7. 7 General Information
- 7. Diagnosis
- 7. Test Mode
- 7. Disassembly
- 7. Connector Function Description46
- 7. Operational Flow Chart
- 8. 8 Operations and Specifications
4. Press key 9 to set ELV/TRAY mode to TRAY.
5. Press key FF to release the clamp and return the tray to the magazine.
6. Press key 9 to enter Elevation Move mode.
7. Use key FF/REV to operate elevation and set if to the graduation of the sixth step
(Fig. 1).
8. Make the adjustment.
Use VR802 to adjust the difference in potential between EREF and EPVO to 0 ±10
mV.
9. When adjustment is completed, press key BAND to exit Mechanism Test mode.
10. Confirm operation of the mechanism.
Place the mechanism horizontally (CD core unit below). Take care not to short-cir-
cuit the PCB.
11. Confirm the height of the stage. Use the DISC± key to select Disc No.6.
Check if the stopper bend of the clamp lever is engaged in the groove of the frame
stopper (Fig. 2-4).
• Note :
The stopper bend will be pressed downward into the groove for final clamping. Confirm the engagement position
of the stopper bend.
• If the stopper bend is engaged in the center and pressed downward, adjustment is completed. Go to step 15.
• If the stopper bend is dislocated, check the amount of dislocation by following steps 12 to 14.
CDX-P1270
Examples of display
TRACK
FUNCTION
72
01' 02"
Release the clamp
TRACK
FUNCTION
72
00' 02"
TRACK
FUNCTION
72
00' 02"
TRACK
FUNCTION
'
"
TRACK
FUNCTION
04
00' 00"
37