Pioneer DEH-1100 설치 매뉴얼 - 페이지 4

{카테고리_이름} Pioneer DEH-1100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DEH-1100 6 페이지. High power cd player with fm/am tuner
Pioneer DEH-1100에 대해서도 마찬가지입니다: 서비스 매뉴얼 (3 페이지)

페이지 인쇄

Installation

Note:

•

Before finally installing the unit, connect the

•

If installation angle exceeds 60° from horizontal,

wiring temporarily, making sure it is all connect-

the unit might not give its optimum performance.

ed up properly, and the unit and the system work

properly.

•

Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts

60°

can cause malfunctions.

•

Consult with your nearest dealer if installation

requires the drilling of holes or other modifica-

tions of the vehicle.

•

Install the unit where it does not get in the dri-

ver's way and cannot injure the passenger if there

is a sudden stop, like an emergency stop.

• The semiconductor laser will be damaged if it

overheats, so don't install the unit anywhere hot

— for instance, near a heater outlet.

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN

Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the

following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush

Holder

After inserting the holder into the dash-

board, then select the appropriate tabs

according to the thickness of the dash-

Dashboard

board material and bend them.

(Install as firmly as possible using the

182

top and bottom tabs. To secure, bend the

tabs 90 degrees.)

Rubber bush

Screw

Removing the Unit

Frame

Insert the release pin into the hole in

the bottom of the frame and pull out

to remove the frame.

(When reattaching the frame, point

the side with a groove downwards

and attach it.)

Insert the supplied extraction keys

into the unit, as shown in the fig-

ure, until they click into place.

Keeping the keys pressed against

the sides of the unit, pull the unit

out.

DIN Rear-mount

Installation using the screw holes on the side of the unit

1. Remove the frame.

Frame

Insert the release pin into the hole

in the bottom of the frame and pull

out to remove the frame.

(When reattaching the frame, point

the side with a groove downwards

and attach it.)

2. Fastening the unit to the factory radio mounting bracket.

Select a position where the screw holes of the bracket and the

screw holes of the head unit become aligned (are fitted), and

tighten the screws at 2 places on each side. Use either truss

screws (5 × 8 mm) or flush surface screws (5 × 9 mm),

depending on the shape of the screw holes in the bracket.

Screw

Dashboard or Console

Factory radio mounting bracket