Pioneer DEH-1950 설치 매뉴얼

{카테고리_이름} Pioneer DEH-1950에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DEH-1950 6 페이지. Installation manual

페이지 인쇄

1. Connecting/Diagram

DEH-2950MP

DEH-1950

DEH-1950G

This product conforms to new cord colors.

Los colores de los cables de este producto se

conforman con un nuevo código de colores.

As cores dos fios deste produto seguem um novo

padrão de cores.

Printed in Thailand

<CRD4139-A/N> ES

Installation

Note:

DIN Front-mount

•

Check all connections and systems before final

installation.

Installation with the rubber bush

•

Do not use unauthorized parts. The use of

Mounting sleeve

unauthorized parts may cause malfunctions.

Dashboard

•

Consult with your dealer if installation requires

drilling of holes or other modifications of the

182

vehicle.

Rubber bush

•

Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

Screw

of a sudden stop.

•

The semiconductor laser will be damaged if it

overheats. Install this unit away from hot places

such as near the heater outlet.

1. Insert the mounting sleeve into the dashboard.

•

Optimum performance is obtained when the unit

•

When installing in a shallow space, use a sup-

is installed at an angle of less than 60°.

plied mounting sleeve. If there is enough

space behind the unit, use factory supplied

mounting sleeve.

60°

2. Secure the mounting sleeve by using a screwdriv-

er to bend the metal tabs (90°) into place.

3. Install the unit as illustrated.

Removing the Unit

•

When installing, to ensure proper heat dispersal

1. Extend top and bottom of the trim ring outwards

when using this unit, make sure you leave ample

to remove the trim ring. (When reattaching the

space behind the rear panel and wrap any loose

cables so they are not blocking the vents.

trim ring, point the side with a groove down-

wards and attach it.)

•

It becomes easy to remove the trim ring if the

DIN Front/Rear-mount

front panel is released.

This unit can be properly installed either from

Trim ring

"Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing

threaded screw holes at the sides of unit chassis).

For details, refer to the following installation

methods.

2. Insert the supplied extraction keys into both sides

of the unit until they click into place.

3. Pull the unit out of the dashboard.

ENGLISH

DIN Rear-mount

1. Extend top and bottom of the trim ring outwards

to remove the trim ring. (When reattaching the

trim ring, point the side with a groove down-

wards and attach it.)

•

It becomes easy to remove the trim ring if the

front panel is released.

Trim ring

2. Determine the appropriate position where the

holes on the bracket and the side of the unit

match.

3. Tighten two screws on each side.

Use either truss screws (5 mm × 8 mm) or

•

flush surface screws (5 mm × 9 mm), depend-

ing on the shape of screw holes in the

bracket.

Screw

Dashboard or Console

Factory radio mounting bracket