Pioneer DEH-7300BT 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Pioneer DEH-7300BT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DEH-7300BT 23 페이지. Cd rds receiver
Pioneer DEH-7300BT에 대해서도 마찬가지입니다: 운영 매뉴얼 (29 페이지), 설치 매뉴얼 (29 페이지)

페이지 인쇄

Operating this unit

WARNING

! Keep the battery out of the reach of children.

Should the battery be swallowed, consult a

doctor immediately.

! Batteries (battery pack or batteries installed)

must not be exposed to excessive heat such

as sunshine, fire or the like.

CAUTION

! Use one CR2025 (3 V) lithium battery.

! Remove the battery if the remote control is

not used for a month or longer.

! There is a danger of explosion if the battery is

incorrectly replaced. Replace only with the

same or equivalent type.

! Do not handle the battery with metallic tools.

! Do not store the battery with metallic ob-

jects.

! If the battery leaks, wipe the remote control

completely clean and install a new battery.

! When disposing of used batteries, comply

with governmental regulations or environ-

mental public institutions' rules that apply in

your country/area.

! "Perchlorate Material – special handling may

apply.

See www.dtsc.ca.gov/hazardouswaste/

perchlorate. (Applicable to California,

U.S.A.)"

Important

! Do not store the remote control in high tem-

peratures or direct sunlight.

! The remote control may not function properly

in direct sunlight.

! Do not let the remote control fall onto the

floor, where it may become jammed under

the brake or accelerator pedal.

Using Bluetooth telephone

Important

! Since this unit is on standby to connect with

your cellular phone via Bluetooth wireless

technology, using it without the engine run-

ning can drain the battery power.

! Operations may vary depending on the kind

of cellular phone.

! Advanced operations that require attention

such as dialing numbers on the monitor,

using the phone book, etc., are prohibited

while driving. Park your vehicle in a safe

place when using these advanced opera-

tions.

Setting up for hands-free phoning

Before you can use the hands-free phoning

function you must set up the unit for use with

your cellular phone.

1 Connection

Operate the Bluetooth telephone connection

menu. Refer to Connection menu operation on

page 8.

2 Function settings

Operate the Bluetooth telephone function

menu. Refer to Phone menu operation on page

Basic Operations

Making a phone call

1 Refer to Phone menu operation on page 9.

Answering an incoming call

1 When a call is received, press M.C.

Ending a call

1 Press

Rejecting an incoming call

1 When a call is received, press

Operating this unit

Answering a call waiting

1 When a call is received, press M.C.

Canceling call waiting

1 Press

Adjusting the other party's listening volume

1 Press a or b while talking on the phone.

Turning private mode on or off.

1 Press B (BAND/ESC) while talking on the

phone.

Switching the information display

1 Press

while talking on the phone.

! Press and hold

to scroll.

Notes

! If private mode is selected on the cellular

phone, hands-free phoning may not be avail-

able.

! The estimated call time appears in the dis-

play (this may differ slightly from the actual

call time).

Menu operations identical

for function settings/audio

adjustments/initial settings/

lists

Returning to the previous display

Returning to the previous list (the folder one level

higher)

1 Press

Returning to the main menu

Returning to the top tier of list

1 Press and hold

Returning to the ordinary display

Canceling the initial setting menu

1 Press B (BAND/ESC).

Returning to the ordinary display from the list

1 Press B (BAND/ESC).

Tuner

Basic Operations

Selecting a band

1 Press B (BAND/ESC) until the desired band

(F1, F2, F3 for FM or AM) is displayed.

Manual tuning (step by step)

1 Press c or d.

Seeking

1 Press and hold c or d, and then release.

You can cancel seek tuning by briefly pressing

c or d.

While pressing and holding c or d, you can

skip stations. Seek tuning starts as soon as

you release c or d.

Storing and recalling stations

for each band

Using preset tuning buttons

When you find a station that you want

to store in memory, press one of the preset

tuning buttons (1 to 6) and hold until the

preset number stops flashing.

Press one of the preset tuning buttons (1

to 6) to select the desired station.

# You can also recall stored radio stations by press-

ing a or b during the frequency display.

Switching the display

Selecting the desired text information

1 Press

Program service name—song title—artist

name

Scrolling the song title/artist name information to

the left

1 Press and hold

Section