Pioneer MVH-X691BS 소유자 매뉴얼 - 페이지 21
{카테고리_이름} Pioneer MVH-X691BS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer MVH-X691BS 29 페이지.
페이지 인쇄
FLASH PATTERN
[SOUND LEVEL 1] to [SOUND LEVEL
Change the illumination effect according to
6]
the sound and bass level.
[LOW PASS 1] to [LOW PASS 6]
[RANDOM1]
[RANDOM2]
[RANDOM3]
DISPLAY FX
[ON], [OFF]
CUTIN FX
[ON], [OFF]
The flash pattern changes according to the
sound level.
The flash pattern changes according to the
bass level.
The flash pattern changes randomly according
to the sound level mode and low pass mode.
The flash pattern changes randomly according
to the sound level mode.
The flash pattern changes randomly according
to the low pass mode.
Set the MIXTRAX special effects on/off.
Turn the MIXTRAX sound effects on/off while
manually changing the tracks.
I
Connections/Installation
In the following, "NW" represents network
mode and "STD" represents standard
mode. According to the connections you
have established, change the speaker
mode to standard mode (STD) or network
mode (NW) (page 5).
A
wARNING
• When speaker output is used by 4
channels, use speakers over
50
W
(maximum input power) and between 4
0
to
8 0
(impedance value). Do not use 1
0
to 3
0
speakers for this unit.
• When rear speaker output is used by 2
0
of subwoofer, use speakers over
70
W
(maximum input power).
*Please refer to connections for a
connection method.
• The black cable is ground. When
installing this unit or power amp (sold
separately), make sure to connect the
ground wire first. Ensure that the ground
wire is properly connected to metal parts
of the car's body. The ground wire of the
power amp and the one of this unit or
any other device must be connected to
the car separately with different screws. If
the screw for the ground wire loosens or
falls out, it could result in fire, generation
of smoke or malfunction.
Ground wire
POWER AMP
~~,,
Other devices
\
(Another electronic
device in the car)
Meta I parts of
car's body
*1 Not supplied for this unit
c!}
Important
• When installing this unit in a vehicle
without an ACC (accessory) position on
the ignition switch, failure to connect the
red cable to the terminal that detects
operation of the ignition key may result
in battery drain.
ACC position
No ACC position
• Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
• To prevent a short-circuit, overheating or
malfunction, be sure to follow the
directions below.
-Disconnect the negative terminal of the
battery before installation.
-Secure the wiring with cable clamps or
adhesive tape. Wrap adhesive tape
around wiring that comes into contact
with metal parts to protect the wiring.
-Place all cables away from moving parts,
such as the shift lever and seat rails.
-Place all cables away from hot places,
such as near the heater outlet.
En
21