Pioneer NC-50DAB 사용 설명서 - 페이지 10
{카테고리_이름} Pioneer NC-50DAB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer NC-50DAB 42 페이지. Network cd receiver
페이지 인쇄
> Before Start
> Part Names
To make Wi-Fi settings, select "Wi-Fi". If you have
connected with an ethernet cable, select "Wired(Exit)" and
confirm. If you select "Wi-Fi", select the method for setting
in the next screen (for example "Scan Networks").
Wireless
Scan Networks
Use iOS Device
Input SSID
0 To redo the initial settings, press SETUP on the remote
controller, select "Wi-Fi" in "Network Setting" -
"Connection", then select "Wi-Fi Setup".
■ Scan Networks
From the list of SSID for access points such as wireless
LAN routers, select the required SSID and make the
settings.
1. Select the SSID of the access point you want to connect
and then confirm.
Wireless
aaaaaaaaaaaaaaaa
bbbbbbbbbbbbbbbbb
ccccccccccccccccccc
ddddddddddddddddd
2. Select either "Enter Password" or "Push Button" and
confirm. If the access point has an automatic setting
button, by selecting "Push Button" you can connect
without entering a password.
10
> Install
> Initial Setup
Wireless
Enter Password
Push Button
3. If you select "Enter Password", enter the password of the
access point and press ENTER. For details on how to
enter text, refer to "Entering text" (
Password
A
[REPEAT]
Change Text
[CLEAR]
Delete One Character
If you select "Push Button", then after pressing and
holding the automatic setting button on the access point
for the required amount of time, press ENTER on the
remote controller.
4.
is displayed when the settings are complete.
■ Use iOS Device
Set by sharing the iOS device's Wi-Fi settings with this unit.
1. Connect the iOS device by Wi-Fi.
2. Select this device in the "SET UP NEW AIRPLAY
SPEAKER..." item on the screen of the iOS device and
select "Next".
0 This unit is displayed as "Pioneer NC-50DAB
> Playback
XXXXXX".
3. After establishing the connection, select "Done" on the
screen of the iOS device.
4.
is displayed on the display of the unit when the
settings are complete.
■ Enter SSID of the access point
Set by entering the SSID of the access point you want to
P29).
connect.
1. Enter the SSID. For details on how to enter text, refer to
"Entering text" (
2. Select and confirm the authentication method.
0 If you select "None", proceed to step 3. If you select
"WEP", "WPA", or "WPA2", enter the password and
confirm.
3.
is displayed when the settings are complete.
Advanced Setup | Firmware Update | Others
P29).
SSID
A
[REPEAT]
Change Text
[CLEAR]
Delete One Character
Security Method
None
WEP
WPA
WPA2
E
N