Pioneer P4000 - CDS CD Player 설치 매뉴얼 - 페이지 2

{카테고리_이름} Pioneer P4000 - CDS CD Player에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer P4000 - CDS CD Player 6 페이지. Level indicator cd player
Pioneer P4000 - CDS CD Player에 대해서도 마찬가지입니다: 운영 매뉴얼 (4 페이지)

페이지 인쇄
Pioneer P4000 - CDS CD Player 설치 매뉴얼

Connecting the units

Connecting the power cord
This product
Antenna input
Fuse (10 A)
Yellow
Connect to the constant 12 V supply terminal.
Red
Fuse resistor
Connect to terminal controlled by ignition switch (12 V DC).
Orange/white
Fuse resistor
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
White
Gray
Front speaker
Front speaker
White/black
Gray/black
Left
Right
Green
Violet
Rear speaker or
Rear speaker or
Subwoofer (4 Ω)
Subwoofer (4 Ω)
Green/black
Violet/black
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not
connect anything to Green and Green/black leads.
Green
Violet
Subwoofer (4 Ω)
Not used.
× 2
Green/black
Violet/black
Connecting the units
Yellow/black
If you use equipment with Mute function, wire this lead to the
Audio Mute lead on that piece of equipment. If not, keep the
Audio Mute lead free of any connections.
Connection method
2. Clamp firmly with
1. Clamp the lead.
needle-nosed pliers.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch.
Parking brake
switch
Power supply side
Blue/white
Connect to system control terminal of the power
Ground side
amp or auto-antenna relay control terminal (max.
300 mA 12 V DC).
With a 2 speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
When you connect the separately sold
Note:
multi-channel processor (e.g., DEQ-P8000) to
· Change the initial setting of this unit (refer to the
this unit, do not connect anything to the
Operation Manual). The subwoofer output of this unit is
speaker leads and system remote control
monaural.
(blue/white).
Connecting the units
When connecting to separately sold power amp
This product
Power amp
(sold separately)
Power amp
(sold separately)
Front output
Connect with RCA cables (sold
Rear output or
separately)
subwoofer output
Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control
terminal.
(max. 300 mA 12 V DC).
System remote control
Left
Right
When you connect the separately sold
Front speaker
Front speaker
multi-channel processor (e.g., DEQ-P8000) to
this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
Rear speaker
Rear speaker
or Subwoofer
or Subwoofer
When you connect the multi-channel processor
to this unit, refer to multi-channel processor's
installation manual for the connection method.
Perform these connections when
Note:
using the optional amplifier.
· Change the initial setting of this unit
(refer to the Operation Manual).
The subwoofer output of this unit is monaural.
Connecting the units
Connecting the system
USB cable
Connect to sparately sold
USB device.
1.5 m (4 ft.11 in.)
This product
20 cm
(7-7/8 in.)
Multi-CD player
iPod with Dock
(sold separately)
connector
Wired remote input
Gray
Hard-wired remote control
Dock connector
adaptor can be connected
2 m (6 ft.7 in.)
(sold separately).
Interface cable
(e.g., CD-I200) (sold separately)