Pioneer Super Tuner III D DEH-P4800MP 운영 매뉴얼 - 페이지 10

{카테고리_이름} Pioneer Super Tuner III D DEH-P4800MP에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Super Tuner III D DEH-P4800MP 36 페이지. Owner's manual
Pioneer Super Tuner III D DEH-P4800MP에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 소유자 매뉴얼 (34 페이지)

페이지 인쇄

MAN-DEH-P4800MP-GB.fm Page 10 Thursday, September 29, 2005 11:55 AM

Tuner

Listening to the radio

These are the basic steps necessary to operate the radio. More advanced tuner

operation is explained starting on this page.

This unit's AF (alternative frequencies search) function can be turned on and off. AF

should be off for normal tuning operation (refer to page 12).

Band indicator

Shows which band the radio is

tuned to, MW/LW or FM.

Preset number indicator

Shows which preset has been

selected.

Frequency indicator

Shows the frequency to which the

tuner is tuned.

Stereo (%) indicator

Shows when the selected

frequency is being broadcast in

stereo.

1. Press SOURCE to select the tuner.

Press SOURCE until you see TUNER displayed.

2. Use VOLUME to adjust the sound level.

Rotate it to increase or decrease the volume.

3. Press BAND to select a band.

Press BAND until the desired band is displayed, FM1, FM2 for FM or MW/LW.

4. To perform manual tuning, briefly press 4 or 6.

The frequencies move up or down step by step.

5. To perform seek tuning, press and hold 4 or 6 for about one second and

release.

The tuner will scan the frequencies until a broadcast strong enough for good reception

is found.

• You can cancel seek tuning by briefly pressing 4 or 6.

• If you press and hold 4 or 6 you can skip stations. Seek tuning starts as soon as

you release the button.

Note

• When the frequency selected is being broadcast in stereo the stereo (%) indicator will light.

Introduction of advanced tuner operation

Function display

Shows the function status.

LOC indicator

Shows when local seek tuning is

on.

* Press FUNCTION to display the

function names.

Press FUNCTION repeatedly to switch between the following functions:

BSM (best stations memory) – REG (regional) – LOCAL (local seek tuning) – TA

(traffic announcement standby) – AF (alternative frequencies search)

• To return to the frequency display, press BAND.

• If MW/LW band is selected, you can only select BSM or LOCAL.

Note

• If you do not operate the function within about 30 seconds, the display is automatically

returned to the frequency display.

Storing and recalling broadcast frequencies

If you press any of the preset tuning buttons 1–6 you can easily store up to six

broadcast frequencies for later recall with the touch of a button.

* When you find a frequency that you want to store in memory, press one of preset

tuning buttons 1–6 and hold until the preset number stops flashing.

The number you have pressed will flash in the preset number indicator and then

remain lit. The selected radio station frequency has been stored in memory.

The next time you press the same preset tuning button the radio station frequency is

recalled from memory.

Notes

• Up to 18 FM stations, six for each of the three FM bands, and six MW/LW stations can be

stored in memory.

• You can also use 8 and 2 to recall radio station frequencies assigned to preset tuning

buttons 1–6.