Pioneer Super Tuner III D DVH-P5850MP 설치 매뉴얼 - 페이지 3

{카테고리_이름} Pioneer Super Tuner III D DVH-P5850MP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Super Tuner III D DVH-P5850MP 43 페이지. Car radio

페이지 인쇄

1. Conexión del Cable de Alimentación

Connecting the Units

• Speakers connected to this unit must be high-

power with minimum rating of 50 W and

impedance of 4 to 8 ohms. Connecting speak-

ers with output and/or impedance values

other than those noted here may result in the

speakers catching fire, emitting smoke or

becoming damaged.

• If the RCA pin jack on the unit will not be

used, do not remove the caps attached to the

end of the connector.

• When this product's source is switched ON, a

control signal is output through the

blue/white lead. Connect to an external power

amp's system remote control or the car's

Auto-antenna relay control terminal (max. 300

mA 12 V DC). If the car features a glass

antenna, connect to the antenna booster

power supply terminal.

• When an external power amp is being used

with this system, be sure not to connect the

blue/white lead to the amp's power terminal.

Likewise, do not connect the blue/white lead

to the power terminal of the auto-antenna.

Such connection could cause excessive cur-

rent drain and malfunction.

• To avoid a short-circuit, cover the disconnected

lead with insulating tape. Insulate the unused

speaker leads without fail. There is a possibility

of a short-circuit if the leads are not insulated.

• To prevent incorrect connection, the input

side of the IP-BUS connector is blue, and the

output side is black. Connect the connectors

of the same colors correctly.

• If this unit is installed in a vehicle that does

not have an ACC (accessory) position on the

ignition switch, the red lead of the unit should

be connected to a terminal coupled with igni-

tion switch ON/OFF operations. If this is not

done, the vehicle battery may be drained

when you are away from the vehicle for sev-

eral hours.

ACC position

• The black lead is ground. Please ground this

lead separately from the ground of high-cur-

rent products such as power amps.

If you ground the products together and the

ground becomes detached, there is a risk of

damage to the products or fire.

• Cords for this product and those for other

products may be different colors even if they

have the same function. When connecting

this product to another product, refer to the

supplied manuals of both products and con-

nect cords that have the same function.

No ACC position