Pioneer X-CM66D 사용 설명서 - 페이지 37
{카테고리_이름} Pioneer X-CM66D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer X-CM66D 39 페이지. Cd receiver system
페이지 인쇄
Additional information
Auto power off setting
1
Press MENU on the remote control.
"Auto Power Down" will be displayed on the main display.
2
Press ENTER on the remote control.
3
Press / to switch auto power off setting
ON/OFF.
• Initial setting is set to ON.
Note
• When the auto power off is set to ON, "APD ON" will be
displayed on the main display.
• When the auto power off is set to OFF, "APD OFF" will
be displayed on the main display.
Advanced network settings
Checking network information
1
Press MENU on the remote control.
2
Press / until "Network INFO" is
displayed, then press ENTER.
3
Press / to select the item you want to
check and press ENTER.
Signal Strength
You can check the stability of the wireless connection.
More
means a more stable connection.
• Adjust the angle of the wireless antenna according to the
connection status.
IP Address
The IP address of this unit is displayed.
MAC Address
The MAC address of this unit is displayed.
Network Type
Either wired LAN (Wired) or Wi-Fi (Wireless) is displayed.
SSID
The SSID of the connected access point will be displayed.
Switching Wi-Fi on and off
1
Press MENU on the remote control.
2
Press / until "Network Type Set" is
displayed, then press ENTER.
3
Press / to switch Wi-Fi setting ON/OFF.
Firmware Update
Checking the current software version
1
Press MENU on the remote control.
2
Press / until "Software Version" is
displayed, then press ENTER.
Updating the software
You can update the software of this unit via the network.
• Connect this unit to the network. (page 9, 11)
1
Press MENU on the remote control.
2
Press / until "Software Update" is
displayed, then press ENTER.
3
While "Network Update" is displayed, press
ENTER.
Restoring all the settings to the
defaults
Use the steps below to restore the all settings to their defaults.
1
Press Í to turn the power on.
2
Press MENU and then press / until
"Factory Reset" appears on the display.
3
Press ENTER.
"OK?" will appear.
4
Press ENTER.
• "Resetting" is displayed while the settings are being
restored. Power is turned off.
11
37
En