Pioneer X-HX2000 작동 지침 - 페이지 29

{카테고리_이름} Pioneer X-HX2000에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer X-HX2000 36 페이지. Cd/receiver system

Press the + or – button to set the

"Minute" for the playback start time,

then press the ENTER button.

Press the + or – button to set the

"Hour" for the playback end time, then

press the ENTER button.

Press the + or – button to set the

"Minute" for the playback end time,

then press the ENTER button.

This causes "OK" to flash in the display

panel.

Adjust the volume level if necessary.

Press the ENTER button.

A timer setting display appears so you can

check your setting.

Sometimes, a green lamp lights on the

TIMER button at this step. In such cases, be

sure to perform steps 10 and 11 below also.

Press the TIMER button repeatedly

until "WAKE UP" appears in the display

panel.

The TIMER button's green lamp goes on.

Press the POWER button (or the

STANDBY/ON button on the remote

control) to turn off the system's power.

The TIMER button should be lit.

Make sure that the system's power is off.

The Wake-up Timer will not operate unless

the system's power is off.

Now, playback will begin at the specified start

time and will end at the specified end time.

To cancel a timer setting (before completing

the setting)

Press the CANCEL button before pressing the ENTER

button at step 9 above.

If the specified playback start and end times

are the same

The TIMER button will not light after you press it at step

10, and the Wake-up Timer will not operate.

If the target disc is not loaded

For example, if you set up the Wake-up Timer to play a

CD (at step 2), then eject the CD before pressing the

TIMER button (at step 10), "NO DISC" appears in the

display panel and the Wake-up Timer will not operate.