Pioneer XC-L7 사용 설명서 - 페이지 21

{카테고리_이름} Pioneer XC-L7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer XC-L7 50 페이지. Stereo cd receiver/stereo cassette deck/ speaker system

페이지 인쇄

CARE OF DISCS

@ With this player, use discs which display the mark

shown below. (Optical audio digital discs.)

@ When holding discs, do not touch their signal sur-

faces. Hold by the edges, or by one edge and the

center hole.

Do not affix gummed

labels or tape to the labei

surfaces. Also, do not scratch or damage the disc.

—

Discs rotate at high speed inside the player. Do not

use damaged (cracked or warped) discs.

COMPACT

DIGITAL AUDIO

CLEANING DISCS

Fingerprints or smudges on the surface of a disc

will not directly affect the recorded signals, but de-

pending on the degree of contamination, the bright-

ness of the light reflected from the signal surfaces

may be reduced, causing degradation

of sound

quality. Always keep your discs clean by wiping

them gently with a soft cloth from the inner edge

toward the outer periphery.

if a disc becomes very dirty, dip a soft cloth in wa-

ter, and after wringing it out well, wipe the dirt away

gently. Remove any water drops with another soft,

dry cloth.

Do not use record cleaning sprays or anti-static

agents on discs. Never clean discs with benzene,

thinner, or other volatile solvents, since damage to

the disc surface may result.

STORING DISCS

Discs are made of the same kinds of plastic used

for conventional analog audio records. Be careful

not to allow discs to warp ; always store discs in

their cases vertically, avoiding locations with high

heat or humidity, or extremely low temperatures.

Avoid leaving discs in cars, since the seat of a car

in direct sunlight can become extremely hot.

@ Always read and abide by the precautionary notes

listed on disc labels.

Is the tape loose, or is some of the tape sticking out

of the cassette?

This will damage the tape itself.

To remove the slack, insert a pen-

cil into the spool and gently wind

it.

Safekeeping

Put the cassette ta pe back into

—

its case and store it in a loca-

ELE?

tion not exposed to magnetic

fields, humidity, dust, or oil.

Tips on using cassette tapes

Leader tape (which does not allow sound to be re-

corded over it) is provided at the beginning of a

cassette tape. Start recording after allowing the tape

to run for approx. 5 seconds so that the leader tape

clears the recording head.

@ Forwarding or reversing the cassette tapes before

recording prevents damage to the unit caused by

tape slack.

Do not use tapes longer than 90 minutes.

Since tapes longer than 90 minutes are so thin, they

easily jam in the pinch roller and capstan, and they

are susceptible to other trouble such as irregular

winding. Try not to use them with this unit.

How can you prevent accidental erasure?

When the tab on the cassette sheil is broken out with

the tip of a screwdriver, it will not be possible to acti-

vate the recording function even by pressing the REC

PAUSE button, so valuable recordings will not be

erased in error.

When you want to record again on a cassette with bro-

For side A

For side B

ken erasure prevention tabs, cover the hole with a dou-

ble layer of adhesive tape.

With TYPE Il (HIGH/CrO:) tapes, be sure not to cover

the tape-type detection holes.

Be sure not to cover the

tape-type detection holes.

En <ARB7126> @