Pioneer XC-P01-K 사용 설명서 - 페이지 14

{카테고리_이름} Pioneer XC-P01-K에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer XC-P01-K 30 페이지. Cd receiver system/ampli-tuner cd
Pioneer XC-P01-K에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (33 페이지), 빠른 시작 매뉴얼 (33 페이지)

페이지 인쇄

1. Specifications

General control

Muting

The volume is muted temporarily when pressing the MUTE

button on the remote control. Press again to restore the

volume.

DIRECT function

Press the DIRECT button on the remote control or on the

stereo receiver to listen to the sound source in the original

sound quality. The DIRECT indicator lights in the front panel

display of the stereo receiver when the DIRECT function is on.

Press the DIRECT button again to cancel the DIRECT

function.

Note

• If the DIRECT function is turned off when the volume is

set to 61 or higher, the volume is automatically set to 60.

Bass control

Press the BASS + button on the remote control to emphasize

the bass, and the BASS – button to de-emphasize it.

Note

• This function is not available when the DIRECT function is

on.

Treble control

Press the TREBLE + button on the remote control to emphasize

the treble, and the TREBLE – button to de-emphasize it.

Note

• This function is not available when the DIRECT function is

on.

Input selection

The input source for the stereo receiver can be selected by

pressing the INPUT button repeatedly or each input selection

button (CD/USB, TUNER, NETWORK, and DIG IN 1/2) on the

remote control, or turning the SOURCE knob on the stereo

receiver.

Note

• If pressing the INPUT button on the remote control

repeatedly or turning the SOURCE knob on the stereo

receiver to the right, the input source is switched in the

following order.

CD/USB

TUNER

NETWORK

DIGITAL IN 2

DIGITAL IN 1

If turning the SOURCE knob to the left, the order is reversed.

• The backup function will memorize the input mode and

restore it in case of a power failure or that the AC power

cord is disconnected.

Headphones

Plug headphones (commercially available) into the PHONES

socket on the stereo receiver.

• Do not turn the volume on to full at switch on and listen

to music at moderate levels. Excessive sound pressure

from earphones and headphones can cause hearing loss.

• Before plugging in or unplugging the headphone, reduce

the volume.

• Be sure your headphone has a 3.5 mm diameter plug and

impedance between 16 and 50 ohms. The recommended

impedance is 32 ohms.

• Plugging in the headphone disconnects the speakers

automatically.

Auto power down setup

The unit turns off automatically if no operations are

performed for specified period of time.

• Default setting: 6H

1 Select the stereo receiver or CD player by pressing the

CONTROL RCV or CONTROL CD button on the remote

control.

2 Press the SETUP button.

3 Press / to specify the amount of time.

You can select 0.5 (CD player only), 2, 4 or 6 hours, or off (if

no automatic shutoff is desired).

4 Press the ENTER button.

Note

• Press the RETURN button to exit the setting mode without

setting the auto power down function.

CAUTION

• If setting the auto power down for the stereo receiver,

both of the stereo receiver and CD player are

automatically turned off after the specified period of time

has elapsed.

If setting the auto power down for the CD player, only the

CD player is automatically turned off after the specified

period of time has elapsed.