Pioneer AVH-280BT 설치 매뉴얼 - 페이지 7
{카테고리_이름} Pioneer AVH-280BT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVH-280BT 48 페이지. Dvd rds av receiver
Pioneer AVH-280BT에 대해서도 마찬가지입니다: 소유자 매뉴얼 (43 페이지), 소유자 매뉴얼 (10 페이지)
페이지 인쇄
Installation
1 2
1 Trim ring
2 Groove
Attach the trim ring with the side with a groove facing
downward.
Installation using the screw
holes on the side of this
product
1 Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes are aligned with
the screw holes of the bracket, and tighten the screws at three
locations on each side.
Use either the truss head screws (5 mm × 9 mm) or flush
surface screws (5 mm × 9 mm), depending on the shape of the
bracket's screw holes.
1
4
3
1 Factory radio-mounting bracket
2 If the pawl interferes with installation, you may bend it down
out of the way.
3 Dashboard or console
4 Truss head screw or flush surface screw
Be sure to use the screws supplied with this product.
Installing the microphone
280BT
Install the microphone in a place where its direction and dis-
tance from the driver make it easiest to pick up the driver's
voice.
Be sure to turn off (ACC OFF) the product before connecting
the microphone.
Mounting on the sun visor
1 Fit the microphone lead into the groove.
1 Microphone lead
2 Groove
2 Attach the microphone clip to the sun visor.
2
1 Microphone clip
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Install the microphone on the sun visor when it is in the up
position. It cannot recognise the driver's voice if the sun visor is
in the down position.
Installation on the steering
column
1 Detach the microphone base from the micro-
phone clip by sliding the microphone base
while pressing the tab.
1
2
1 Tab
2 Microphone base
2 Mount the microphone on the steering column.
1
2
1
2
7