Pioneer DVH-330UB 운영 매뉴얼 - 페이지 11

{카테고리_이름} Pioneer DVH-330UB에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DVH-330UB 40 페이지. Dvd rds receiver
Pioneer DVH-330UB에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

Operating this unit

! Do not let the remote control fall onto the

floor, where it may become jammed under the

brake or accelerator pedal.

WARNING

! Keep the battery out of the reach of children.

Should the battery be swallowed, consult a

doctor immediately.

! Batteries (battery pack or batteries installed)

must not be exposed to excessive heat such

as sunshine, fire or the like.

CAUTION

! Use one CR2025 (3 V) lithium battery.

! Remove the battery if the remote control is not

used for a month or longer.

! There is a danger of explosion if the battery is

incorrectly replaced. Replace only with the

same or equivalent type.

! Do not handle the battery with metallic tools.

! Do not store the battery with metallic objects.

! If the battery leaks, wipe the remote control

completely clean and install a new battery.

! When disposing of used batteries, comply

with governmental regulations or environmen-

tal public institutions' rules that apply in your

country/area.

Menu operations identical

for function settings/audio

adjustments/initial

settings/lists

Returning to the previous display

Returning to the previous list (the folder one level

higher)

1 Press

Returning to the main menu

1 Press and hold

Returning to the ordinary display

Canceling the initial setting menu

1 Press B (BAND/ESC).

Tuner

Basic operations

Selecting a band

1 Press B (BAND/ESC) until the desired band (F1,

F2 for FM or MW/LW) is displayed.

Manual tuning (step by step)

1 Press c or d.

Seeking

1 Press and hold c or d, and then release.

You can cancel seek tuning by briefly pressing c

or d.

While pressing and holding c or d, you can skip

stations. Seek tuning starts as soon as you re-

lease c or d.

Note

This unit's AF (alternative frequencies search)

function can be turned on and off. AF should be

off for normal tuning operation (refer to the next

page).

Storing and recalling stations

for each band

Using preset tuning buttons

When you find a station that you want

to store in memory, press one of the preset

tuning buttons (1 to 6) and hold until the

preset number stops flashing.

Press one of the preset tuning buttons

(1 to 6) to select the desired station.

# You can also recall stored radio stations by

pressing a or b during the frequency display.

Switching the RDS display

RDS (radio data system) contains digital infor-

mation that helps search for the radio sta-

tions.

% Press

Program service name—PTY information—

Frequency

# PTY information and the frequency appear on

the display for eight seconds.

Section