Pioneer Elite SC-05 사용 설명서 - 페이지 8

{카테고리_이름} Pioneer Elite SC-05에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite SC-05 38 페이지. Audio/video multi-channel receiver, advanced mcacc pc display application software
Pioneer Elite SC-05에 대해서도 마찬가지입니다: 사양 (2 페이지)

페이지 인쇄
Pioneer Elite SC-05 사용 설명서
Operations on the Receiver and Cable Connections (Continued)
2
Perform the "Full Auto MCACC" operation on the receiver. (See page 10 of the
receiver's Operating Instructions.)
The setting here is not required if the "Full Auto MCACC" operation has already been performed before
connecting the RS-232C cable. Proceed to
3
From the receiver's "Manual MCACC" menu, select "EQ Professional", then select
"Reverb Measurement" to measure the room's reverb characteristics.
(See page 50 of the receiver's Operating Instructions.)
If you want to measure the room's reverb characteristics, select "EQ OFF", then select "START".
If you want to measure the room's reverb characteristics after equalization, first perform the "Full Auto
MCACC" operation, then select "EQ ON", then "START". (See
Note
Measure the room's reverb characteristics after equalization with the microphone at the same position as
when the "Full Auto MCACC" operation was performed. The measurements are performed with the EQ
values stored in the MCACC memory selected on the receiver, so before measuring the reverb
characteristics, select the MCACC memory to be measured after equalization.
4
Select "Output PC" from "MCACC Data Check". (See page 72 of the receiver's

Operation Instructions.)

The message "Start the MCACC application on your PC" appears and the receiver enters transmission
standby mode. It is ready to send data to your PC.
This completes the preparations for sending the measurement data to your PC.
(To send the data, proceed to the next section Application Operations.)
step
1c5a.Reverb Measurement
MCACC
Reverb Measure with :
Exit
1c5a.Reverb Measurement
MCACC
Reverb Measure with :
Exit
2.MCACC Data Check
A/V RECEIVER
a. Speaker Setting
b. Channel Level
c. Speaker Distance
d. Standing Wave
e. Acoustic Cal EQ
f. Group Delay
g. Output PC
Exit
Return
3.
A/V RECEIVER
: M1.MEMORY 1
EQ OFF
START
Cancel
page
23.)
A/V RECEIVER
: M1.MEMORY 1
EQ ON
START
Cancel
2g.Output PC
A/V RECEIVER
Start the MCACC application on your PC.
Exit
8
Cancel