Pioneer Elite SC-25 사용 설명서 - 페이지 35

{카테고리_이름} Pioneer Elite SC-25에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite SC-25 36 페이지. Audio/video multi-channel receiver, advanced mcacc pc display application software
Pioneer Elite SC-25에 대해서도 마찬가지입니다: 사양 (2 페이지), 펌웨어 업데이트 지침 (5 페이지), 펌웨어 업데이트 지침 (4 페이지)

Pioneer Elite SC-25 사용 설명서
Troubleshooting (Continued)
The receiver causes a malfunction when it is connected to the PC with an RS-232C
cable
Cause:
When the receiver is connected to your PC with an RS-232C cable, the power of
the receiver may be automatically switched on when you operate the PC.
Unplug the cable when not in use.
EQ response in the graph (following calibration) does not appear flat
Cause 1:
The slope of the graph indicates the reverb characteristics. The reverb
characteristics of the room itself cannot be corrected by equalization alone, so
the angle of the graphs' slope is the same before and after calibration.
Through calibration, the graphs for the different frequencies move horizontally by the amount of the
equalization. For the results of calibration, you can check that the graphs line up at a specific point on
the time axis.
The reverb characteristics themselves (the shape of the graph) do not change unless the listening
environment is improved.
(See pages
18
to 20.)
Cause 2:
For various reasons, the frequency characteristic graphs may not become flat
even when equalization is performed with the "SYMMETRY" or "ALL CH ADJ"
functions.
With MCACC, calibration is performed automatically to achieve the optimum sound quality, but without
any unreasonable calibration.
Adjustments made with the "Manual MCACC" setup do not change the graph
Cause:
Despite level adjustments being made, the filters used for analysis may not
display these adjustments in the graphical output.
However, these adjustments are taken this into account by the filters dedicated to overall system
calibration.
Lower frequencies do not seem to have been calibrated for SMALL speakers
Cause:
Low frequency calibration with the equalizer is not performed for speakers that
are set to "SMALL", but the reverb characteristics display shows the pure
characteristics of the sound output from the speakers, so it indicates the
characteristics with no low frequency calibration.
With MCACC, optimum calibration is performed in function of the speakers' sound reproduction
capacities, so there is no problem for low frequency calibration of speakers that are set to "SMALL".
35