Pioneer HTP-071 사용 설명서 - 페이지 6

{카테고리_이름} Pioneer HTP-071에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer HTP-071 10 페이지. Home cinema package, subwoofer and speaker system
Pioneer HTP-071에 대해서도 마찬가지입니다: 데이터시트 (1 페이지), 사용 설명서 (31 페이지)

페이지 인쇄

Connections and Use

Connection

Before making or changing the

connections, switch off the power and

disconnect the power cord from the AC

outlet.

Connecting the speakers

To get the best out of your speakers it is

important that you connect them properly to

your receiver. Each speaker connection

consists of a positive (+) and a negative (–)

terminal. These should be matched between

the receiver and the speaker.

1 Attach one end of the supplied speaker

cord to the rear of the each speaker.

• Connect the wire with the colored

marker to the red (+) terminal; the plain

wire to the black (–) terminal. Press

down the spring-loaded tab and insert

the wire, as shown below. Release the

tab to secure the wire.

Red (+)

Black (–)

2 Connect the other end of each speaker

cord to your receiver.

• To connect, insert the colored wire into

the matching positive (colored) terminal

and the other wire into the negative

(black) terminal. See also the Operating

Instructions that came with your

receiver.

Red colored marker

• These speaker terminals carry

HAZARDOUS LIVE voltage. To prevent the

risk of electric shock when connecting or

disconnecting the speaker cords,

disconnect the power cord before touching

any uninsulated parts.

• After connecting the plugs, pull lightly on

the cords to make sure that the ends of the

cords are securely connected to the

terminals. Poor connections can create

noise and interruptions in the sound.

• If the cords' wires happen to be pushed out

of the terminals, allowing the wires to come

into contact with each other, it places an

excessive additional load on the receiver.

This may cause the amp to stop

functioning, and may even damage the

receiver.

• When using a set of speakers connected to

an receiver, you won't be able to obtain the

normal stereo effect if the polarity (+, –) of

one of the speakers (left or right) is

reversed.

Operation

• Set the receiver's cross-over frequency

at 200 Hz.