Pioneer SC-LX502 기본 매뉴얼 - 페이지 5

{카테고리_이름} Pioneer SC-LX502에 대한 기본 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SC-LX502 36 페이지.
Pioneer SC-LX502에 대해서도 마찬가지입니다: 제품 참조 매뉴얼 (41 페이지)

> Before Start

> Part Names





Rear Panel

1. COMPONENT VIDEO IN jacks: Input the AV component video signals with a component

video cable. (Compatible only with 480i or 576i resolution.)

2. ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio cable to a pre-

main amplifier or a power amplifier in a separate room (ZONE 2).

3. AUDIO IN jacks: Input AV component audio signal with an analog audio cable.

4. VIDEO IN jacks: Input the AV component video signals with an analog video cable.

5. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable connected to

an AV component.

6. HDMI OUT jacks: Transmit video signals and audio signals with a HDMI cable connected

to a monitor such as a TV or projector.

> Install

> Initial Setup



  







> Playback













7. SIGNAL GND terminal: The ground wire of the turntable is connected.

8. NETWORK port: Connect to the network with an Ethernet cable.

9. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio

signals with a digital optical cable or digital coaxial cable.

10.Wireless antenna: Used upright for Wi-Fi connection or when using a BLUETOOTH

enabled device. The diagram shows the movable range for the wireless antenna. Do not

try to force it beyond this range otherwise you may break it.

11. AC IN: The supplied power cord is connected.

12.RS-232C port: For connection to the home control system. (*)

13.ANTENNA AM LOOP/FM UNBAL 75≠ terminal: The supplied antennas are connected.

14.IR IN/OUT port: Allows you to connect a multiroom remote control kit. (*)

(*)You can find details in the Advanced Manual.





