Pioneer SX-316-S 사용 설명서 - 페이지 27

{카테고리_이름} Pioneer SX-316-S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SX-316-S 30 페이지. Audio multi-channel receiver
Pioneer SX-316-S에 대해서도 마찬가지입니다: 사양 (1 페이지), 사양 (1 페이지), 서비스 매뉴얼 (5 페이지), 운영 지침 (2 페이지)

페이지 인쇄

Additional information

Chapter 7:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Take a look at the other

components and electrical appliances being used, because sometimes the problem may lie there.

If the trouble isn't sorted out even after going through the checks below, ask your nearest Pioneer

authorized independent service company to carry out repair work.

• If the unit does not operate normally due to external effects such as static electricity,

disconnect the power plug from the outlet and insert again to return to normal operating

conditions.

Problem

The power does not turn on.

No sound is output when a

function is selected.

Considerable noise in radio

broadcasts.

Broadcast stations cannot be

selected automatically.

Remedy

• Connect the power plug to the wall outlet.

• Disconnect the power plug from the outlet, and insert again.

• Make sure there are no loose strands of speaker wire touching the

rear panel. This could cause the receiver to shut off automatically.

• If the power shuts off automatically, take the unit to your nearest

Pioneer authorized service center or your dealer for servicing.

• Make sure the component is connected correctly (refer to Connecting

up on page 7).

• Press MUTE on the remote control to turn muting off.

• Adjust the MASTER VOLUME.

• Tune in the correct frequency.

• Connect the antenna and adjust the direction and position for best

reception(refer to page 9).

• Route any loose cables away from the antenna terminals and wires.

• Fully extend the FM wire antenna, position for best reception, and

secure to a wall.

• Connect an outdoor FM antenna (refer to page 10).

• Connect an additional internal or external AM antenna (refer to

page 10).

• Turn off the equipment causing the noise or move it away from the

receiver.

• Move antennas farther away from equipment causing the noise.

• Connect an outdoor antenna (refer to page 10).